Feature: 1. Motion sensor: The wall lamp adopts human motion sensing lighting technology, which is sensitive and energy-saving. 38LEDs, high brightness, large irradiation area. 2. 3 lighting modes: It has 3 modes, which are controlled by pressing the switch. The first gear is the induction + low-light mode (it is bright for 10 seconds when people come, and it is slightly bright when people walk). The second gear is the induction mode (the light is on for 10 seconds when people come, and the lights are off when people leave). The third gear is the always-on mode (automatic light on when it is dark, and automatic shutdown after 5 hours). The induction delay time is 10 seconds. If the induction delay trigger time is not over, the time will be restarted. 3. Solar powered: The 6V/2.5W high-power solar panel adopts a laminate design, and the bottom plate adopts an aluminum substrate. The matte surface is not reflective, and the light absorption ability is stronger. 4. Outdoor lighting: Solar wall light is suitable for outdoor lighting, ideal for courtyard, garden, pathway, balcony, fence, corridor. Warm light, soft and not harsh. 5. Sturdy and waterproof: The light is made of PC+ABS material, sun-resistant, heat resistant, sturdy and durable. And it is IP65 waterproof, not afraid of rainy days. Specifications: Color: Black Material: PC+ABS Light source: 38LEDs Light color: Warm Lighting time: About 10-20 hours in induction mode Lighting mode: Strong bright + slightly bright / strong bright / always bright Waterproof level: IP65 Induction distance: About 6-10m Sensing angle: 120 Solar panel: 6V/2.5W Power by: Built-in 3.7V 4400mAh battery Output power: 5W Luminous flux: 600LM Color temperature: 4000-4500K Size: About 210 x 85 x 115mm/8.27 x 3.35 x 4.53inch(length x lighting panel width x height) Package Includes: 1pc x Wall lamp 1pack x Screw 1pc x Chinese and English manual Note: 1. Due to the light and screen difference, the items color may be slightly different from the pictures. 2. Please allow 0.5-2 cm differences due to manual measurement. 3. Please fully charge the device under sunlight before first use. 4. If there is no enough sunlight in 3 months, the battery may run completely flat, and will decrease battery life, so please charge in time. Once its fully charged, unlock the device and lighting system. Otherwise, it wont work anymore. 5. If there is no enough sunlight, especial in North countries. it may take longer time to fully charge the device. This is very normal for solar products. How to install: 1. Use an impact drill (not included) to punch two small holes on the wall (recommended height of about 3.5 meters). 2. Plug the two expansion columns. 3. Tighten the two screws. 4. Press and hold the screw down and the installation is complete.