Features: brand new and high quality The Platform Cable USB ,a USB compatible cable for in-circuit configuration and programming of all Xilinx devices.It derives all operating power from the hub port controller. No external power supply is required. A sustained slave-serial FPGA configuration transfer rate of 24 Mb/s is possible in a Hi-Speed USB environment. Using CY7C68013A+XC2C256 solution, fully for the original xilinx Platform Cable USB Supports all Xilinx devices, FPGA configuration and PROM/CPLD programming;Supports Jtag, Slave-Serial and SPI. Interfaces to devices operating at 5V (TTL), 3.3V (LVCMOS), 2.5V, 1.8V and 1.5V Selectable target clock frequency, supports software automatic frequency adjustment Supported on for Windows and Red Hat Enterprise Linux Automatically senses and adapts to target I/O voltage Target clock speeds are selectable from 750 kHz to 24 MHz. Specifications: Size:approx 110x50x20mm/ 4.33x1.97x0.79in Model: DLC9LP Power: 5V 0.07A Supported Software: Xilinx ISE 8 to ISE 14.7 and up-to-date ISE software/ Xilinx Vivado/ IMPACT/ ChipScope Microblaze embedded processor debugging Supported Device: All Xilinx devices, FPGA and PROM/CPLD:/ All Virtex-FPGA families/ All Spartan-FPGA families XC9500 / XC9500XL / XC9500XV CPLDs/ CoolRunnerXPLA3 / CoolRunner-II CPLDs XC18V00 ISP PROMs/ Platform Flash XCF00S/XCF00P/XL PROMs XC4000 series FPGAs/ for Fresh Xilinx devices including V7, Z7 etc. Note: Due to the problems of lighting effects and shooting angles, there will be certain tolerances in the product, please understand. Please allow 0-1cm error due to the manual measurment Package includes: 1 PC x Platform Cable USB 1 PC x Jtag adapter 1 PC x USB 2.0 cable 1 PC x 8-pin to 7-pin separated robin cable 1 PC x 14-pin (2.5mm pitch) Jtag flat cable 1 PC x 14-pin (2mm pitch) Jtag flat cable 1 PC x 10-pin (2.5mm pitch) Jtag flat cable