High flow and good performance thermostatic mixing valve, suitable for domestic hot water, with or without underfloor heating circuit The integrated temperature control device provides the safety function against -burning the family hot water system It is suitable for domestic hot water appliances or underfloor heating to meet the requirements of constant temperature range and flow rate No matter how the water temperature and pressure changes, it can ensure stable water RangeThe temperature range is 35-60 degrees.In case of cold water failure, the safety device will automatically stop the hot water supply to prevent scalding. Note 1. Products to be constant temperature. What is the highest temperature? What is the lowest temperature? Answer: As long as the temperature of the water source is supported by the domestic thermostatic valve, the maximum theoretical temperature can be from 1 to 99 degrees, the maximum temperature is the temperature of the hot water source (the thermostatic valve core only enters the hot water, and the cold water is closed) , and the lowest temperature is the temperature of the cold water source (constant The door only enters cold water, closes the hot water inlet); 2. Are the actual temperature and the set display temperature incorrect? Answer: The temperature is stable, but the degree deviation is caused. by the water environment, which is not a quality problem. of the product. The product has been tested before leaving the factory (the standard pressure of the ambient cold and hot water source is 0.3MPa, the temperature of the hot water source is 55-65 degrees, and the temperature temperature of cold water is 5 to 28 degrees), and the accuracy and stability error water outlet temperature is plus or minus 1 degree. The accuracy of the leaving water temperature is directly related to the difference in temperature and pressure of the water source. Domestic water pressure usually has a pressure difference, and the temperature of the water source may not be ideal, so the scale may deviate, but after adjusting once, the water environment will not change and the temperature will remain the same the next time it is turned on. . 3. The integrated non-return valve of the thermostatic valve affect the water pressure? Answer: The check valve can effectively prevent the cold and hot water pipes from passing water when the difference in pressure between cold water and hot water is important. The installation of the check valve has some influence on the water pressure. As long as the original hot water pressure is sufficient, the use is generally not affected. 4. If hot water at 40 degrees is needed, but the temperature of the water heater is only 38 degrees, can the water be drained? Answer: When the outlet water temperature is higher than the water heater temperature, the maximum outlet water temperature is the water heater temperature; It is a fairly thermostatic tap, introducing only hot water and closing the cold water supply. On the contrary, enter only cold water, not hot water. So if the hot water temperature is only 38 degrees, only 38 degrees of water will be produced. 5 . I fixed it to 38 degrees. Suddenly the hot water temperature rose. is it hot Answer: No, the thermostatic slider regulates the temperature by controlling the input ratio of the thermostat. and cold and hot water. When the temperature is high, the hot water to the inlet will automatically decrease and the cold water will increase to keep the temperature stable. The reverse is also the case. 6. The scale on the handle is only 30 to 30. 48 degrees, does that mean the temperature can only be in between? Answer: This is just a commonly used temperature reminder. for safety. Because the household water environment is versatile, the actual application scope is wider. As long as the temperature of the water source is supported, the water temperature can theoretically withstand 1 to 10 minutes. 99 degrees.