Stepper Motor Driver, Two-Phase CNC Controller 0.2-5A TB6600 DC12-48V Input

Features The driver adopts the current loop subdivision control of the driver, the motor torsion ripple is small, the low speed operation is very stable, and there is almost no vibration and noise. The two-phase hybrid stepping motor has a dynamic voltage of 12 to 48 V, a current of less than 5 A, and an outer diameter of 35 to 86 mm. Average current control, two-phase sinusoidal current drive output and opto-isolated signal input/output Widely used in engraving machines, CNC machine tools, packaging machinery, etc. High-speed torsion is much higher than other two-phase drives, high positioning accuracy Specification:Item Type: Input Voltage: DC 12-48V Input Input: 1-5A Current, Select Drive Stepper Motor Output Current: 0.2A-5A Temperature Operating Temperature: -10-45℃; Storage Temperature -40℃ -70℃ Humidity: No Condensation, No Drop Gas prohibits combustible gas and conductive dust Set the Number of Steps Per Motor Step for the Motor 200(synchronizing), 400 (2 segments), 1600 (8 segments), and 3200 Steps (16 segments). Power Interface: 1. DC +, DC-: Connect the drive power DC +: DC Power Supply Level, Power Supply Voltage Dc 12 To 48v, Maximum Current 5a DC-: DC Power Supply Negative Level. 2. A + A-B + B-: Connecting Two-Phase Hybrid Stepping Motor The connection between the driver and the two-phase hybrid stepping motor and the four-wire system, the parallel and series connection of the motor windings, and the connection method, the high-speed performance is high, but the driving current is large (the motor winding current is 1.73 times), when the driving current is equal series connection when the motor winding current Troubleshooting: Package List:1 x TB6600 Stepper Motor Driver Package List 1 x TB6600 Stepper Motor Driver