Sensor Infrared Safety Beam Photocell Detector DC/AC 12~24V for Garage Gate Door

₹1,649.00
+ ₹767.99 शिपिंग

Sensor Infrared Safety Beam Photocell Detector DC/AC 12~24V for Garage Gate Door

  • ब्रांड: Unbranded

Sensor Infrared Safety Beam Photocell Detector DC/AC 12~24V for Garage Gate Door

  • ब्रांड: Unbranded
RRP: ₹10,290.00
मूल्य: ₹1,649.00
आपकी बचत: ₹8,641.00 (83%)
द्वारा बेचा गया:
₹1,649.00
+ ₹767.99 शिपिंग

स्टॉक में है

हम निम्नलिखित भुगतान विधियाँ स्वीकार करते हैं

विवरण

Sensor Infrared Safety Beam Photocell Detector DC/AC 12~24V for Garage Gate Door Battery-powered Motion Sensor Infrared Photocell Sensor Sliding Gate Barrier Garage Door For Doorhan DITEC HORMANN Sommer Used for automatic slide door, automatic Gate Door, coil door , garage door windows barrier etc. Feature Receiver and Transmitter Consists of a transmitter and a receiver, and the integrated amplifier can produce infrared beam. Anti-interference Narrow infrared beam (I or II) can avoid interruption by external light Detection distance Even installed at low height(20-40cm from the floor), the detecting distance can also be guaranteed(5-10meters). self-detecting function The beam produced by MICROCELL provides a self-detecting function for the sliding doors. Once the self-detecting beam is interrupted, the door will stop closing and reverse rapidly to the utmost width. The door will open until the detecting beam is resumed. When the door completely closes, the detecting beam becomes invalid. Technical Specification Working voltage: Transmitter : 3.6V (14250 battery ) NOT IncludeReceiver : 12-24V DC Working current: Transmitter < 85A, Receiver < 30mA (24V DC) Photocell wavelength: 940nm Angle of emission:5 Receiving range:> 12m Relay contact loading capacity:1A/30VDC Size:100*40*35mm Note No battery included and the buyer needs to prepare the battery themselves! Safety Instruction 1.For security, please read the user manual carefully before initial operation; 2.This photocell is without any fuse,so Please make sure the power is off before installation; 3.Only used this system that do not cause any danger life or property during the running failure or its security risks eliminated; 4.Please guarantee the products used in effective working range Picture Display Installation instruction 4.1 Receive module J4 in above picture is the option switch for NO and NC of photocell switch. 4.1.1When the short circuit cap on NO,it is normally open. 4.1.2 When the short circuit cap on NC,it is normally closed. 4.2 Installation 4.2.1 The photocell should be installed more than 20cm above the ground (to avoid reflection), and the distance between emitter and receiver should be more than 50cm. 4.2.2 End user should install the photocell receiver on the back of the direct sunlight or other strong light source(5-) to keep photocell work well steadily. 4.2.3 Avoid installing other infrared photocell emitters within the effective distance of receiver. 4.2.4 If the end user need to install other photocells in one same straight line , the receivers could be installed in the two ends and the emitters could be back-to-back installed. 4.2.5 Stable installation could avoid the signal of emitter and receiver skewing due to lightly vibrate and the malfunction. 4.2.6 When the product is install in some place with angle , end user could adjust the PCBA to make the installation better. 4.2.7 Connect the power after the inspection, when short circuit cap at NO, After the battery is installed on the LED lamp of the transmitting module, the LED lamp lights up for 0.5 seconds and then goes out, receiver module LED turns on, receiver module contact at off; when make the cap of emitter and receiver in alignment, receiver module LED is off, NC/NO is on ;when something or someone shelter the sensor, receiver module LED will turn on , NC/NO contact is off. When short circuit cap at NC, the state of NO/NO is opposite to the above phenomenon. Installation Pictures _x000D_
  • Fruugo ID: 428984276-901269143
  • EAN: 7803430603888

उत्पाद सुरक्षा जानकारी

कृपया नीचे दी गई इस उत्पाद से संबंधित विशिष्ट उत्पाद सुरक्षा जानकारी देखें

निम्नलिखित जानकारी इस उत्पाद को बेचने वाले स्वतंत्र तृतीय-पक्ष खुदरा विक्रेता द्वारा प्रदान की गई है।

उत्पाद सुरक्षा लेबल

CE Mark
सुरक्षा चेतावनियाँ: WARNING! TO AVOID DANGER OF SUFFOCATION,KEEP AWAY FROM BABIES ANDCHILDREN. DO NOT USE IN CRIBS/BEDSOR PLAY PENS.THIS BAG IS NOT ATOY.
सामग्री: Octinoxate 7.1144%
निर्माता भाग संख्या: SJ272034
मॉडल नंबर: SJ331068
क्रम संख्या: SJ100257
बैच संख्या: SJ011435

डिलीवरी और वापसी

3 दिनों के भीतर भेजा जाएगा

  • STANDARD: ₹767.99 - के बीच वितरण मंगल 11 नवंबर 2025–गुरु 20 नवंबर 2025

चीन से शिप हो रहा है।

हम आपके द्वारा ऑर्डर किए गए उत्पादों को पूरी तरह से और आपके विनिर्देशों के अनुसार डिलीवर करने की पूरी कोशिश करते हैं। हालाँकि, यदि आपको अधूरा ऑर्डर या आपके ऑर्डर से कोई अलग आइटम प्राप्त होता है या किसी अन्य कारण से यदि आप अपने ऑर्डर से संतुष्ट नहीं हैं तो आप ऑर्डर या ऑर्डर में शामिल कोई भी उत्पाद वापस कर सकते हैं और आइटम के लिए पूर्ण रिफ़ंड प्राप्त कर सकते हैं। सम्पूर्ण वापसी पॉलिसी दिखाएँ

उत्पाद अनुपालन विवरण

कृपया नीचे दी गई इस उत्पाद से संबंधित विशिष्ट अनुपालन जानकारी देखें।

निम्नलिखित जानकारी इस उत्पाद को बेचने वाले स्वतंत्र तृतीय-पक्ष खुदरा विक्रेता द्वारा प्रदान की गई है।

निर्माता:
नीचे Fruugo पर बिक्री किए जाने वाले संबंधित उत्पाद निर्माता के संपर्क विवरण की जानकारी संबधी सूचना है।

  • Bosidun Shenzhen Keji Youxian Gongsi
  • Bosidun Shenzhen Keji Youxian Gongsi
  • Longgangqu Pinghu Jiedao Hehua Shequ Huanan Dadao Yi Hao
  • Huanan Guoji Fangzhi Fuzhuang Yuanfuliao Wuliuqu Erqi
  • Shenzhen
  • China
  • 518000
  • laureenoun@163.com
  • 15678247948
  • https://www.fruugoschweiz.com/bosidun-shenzhen-keji-youxian-gongsi/m-18796

यूरोपीय संघ(EU) में जिम्‍मेदार व्यक्ति:
नीचे यूरोपीय संघ में जिम्मेदार व्यक्ति की संपर्क जानकारी संबंधी सूचना है। जिम्मेदार व्यक्ति यूरोपीय संघ में स्थित पदनामित आर्थिक ऑपरेटर है जो यूरोपीय संघ में बिक्री किए जाने वाले संबंधित उत्पाद संबंधी अनुपालन दायित्वों के लिए जिम्मेदार है।

  • EC REP SERVICES SL
  • EC REP SERVICES SL
  • Calle Gran Via 49, 7 DCH.
  • Madrid
  • Spain
  • 28013
  • ECREPSERVICE@HOTMAIL.COM
  • 34682797075