SMA female antenna port - Universal dongles use the less common MCX or PAL antenna ports. SMA is more common, so more adapters and antennas are available for it. It is also more and has lower RF insertion losses.HF reception in Direct Sampling Mode - Listen to 100 kHz - 25 MHz with direct sampling. Simply connect an HF antenna to the SMA port, and choose the Q-branch mode. There is a built in 25 MHz low pass filter, but additional HF filters may be required for optimal performance (e.g. to attenuate strong MW AM).Better Cooling system, big Aluminium case and passive cooling - These units come stock with an aluminium case and passive cooling via two cooling fans. And the PCB board is designed especialy for passive cooling design by the cooling holes and big aluminum enclosure. This stops reception failing due to heat above ~1.2 GHzUse R820T2 tuner, higher quality passive components, a on the USB line to reduce USB noise, a much improved PCB design for significantly less internal spurs and noise, various break-out pads, improved ESD protection, additional bypass capacitors and ferrite power line chokes, improved front end matching circuit and a better .Lower overall noise, more sensitivity.Can tune from 100 kHz to 1.8 GHz and has up to 3.2 MHz (2.4 MHz stable) of instantaneous bandwidth. (HF reception below 24 MHz runs in direct sampling mode)With LNA, low noise amplifier for the HF signals. 10 times amplification than normal HF reception.Great for many applications including general radio scanning, air traffic control, public safety radio, ADSB, , ACARS, trunked radio, P25 digital voice, POCSAG, weather balloons, APRS, APT weather satellites, radio astronomy, meteor scatter monitoring, , or for use as a low cost panadapter with a traditional ham radio.colour:Random Color(Random color, dont accept the specified color.)Material:metalDifferent batches, there may be color difference.Package Contents:1 x RTL SDR receiverOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.