Car Rear View Reverse Backup Parking Camera with Cable Harness Fit for Toyota 4Runner 1996-2001 Product Specifications Condition: 100% new Color: Black & Clear Material: Metal & Plastic Size: As picture shows Video Cable Length: approx. 600 cm(236.22 inch) Power Supply Cable Length: approx. 92 cm(39.37 inch) Sensor: 1/4" Color CMOS TV system: NTSC and PAL Resolution: 480 TV Lines Power Supply: 12V10% DC 80mA/100mA IP Rating: IP67 Minimum illumination: 0.2Lux Operating temperature: -30 to +80 (RH95% Max.) Placement on Vehicle: License Plate, Rear Detection Angle: 170 Degree Features: Waterproof, Night Vision, High Definition, 170 degree Wide Angle Lens and Guide Line Item included: 1 x Rear View Camera 1 x 6m Camera Video Cable 1 x Power Cable Compatible With: fit for Toyota 4Runner 1996-2001 This Is Aftermarket Replacement Item But Not Genuine Note: 1) All dimensions are measured by hand, there may be small deviations. 2) Color may vary slightly due to the color setting of each individual monitor. Product Description Product Dimension: Feature: 1) According to the original factory specifications. 2) Signal to noise ratio is greater than 46 DB. 3) High Clear, Night Vision (No IR), Waterproof, ABS material, Guide Line. 4) 170 degree view angle, very small, and easy for installing. 5) Low illumination and fill light automatic, waterproof. 6) Easy installation. 7) Stable characteristics, high reliability. Installation Guide: 1) Take out your stock license plate light at the back of your car. 2) Fix the camera to where the stock license plate light was. 3) Connect the built-in license plate light of the camera to where the stock license plate light was connected to get the power. 4) Connect the power of the camera to your reverse lights - red wire to positive and black wire to negative. 5) Connect the video cable of the camera to the extension cord. 6) Connect the extension cord to your car monitor. 7) You will see the images when your car is in reverse shift.