Features Optimized for 5.8GHz Receiver: This filter features low in-band insertion loss and steep cut-off characteristics, ensuring optimal performance for your 5.8GHz receiving devices Enhanced Signal Clarity: Effectively filters out-of-band signals to reduce noise, significantly improving dynamic range for clearer and more reliable communication Superior Out-of-Band Suppression: Achieves better suppression of unwanted remote signals compared to standard PCB bare board products, enhancing overall signal integrity Durable Aluminum Alloy Construction: Crafted with a shielded aluminum alloy shell to minimize interference and eliminate out-of-band spurious responses for consistent performance Versatile SMA Interface: Designed with symmetrical SMA male and female interfaces, offering easy installation with no directionality for seamless integration into your system Features: 1、[FOR 5.8GHZ RECEIVER] This filter has low in band insertion loss, with steep cut off characteristics, is dedicated to 5.8GHz receiving device. 2、[HIGH EFFICIENCY] The bandpass filter can effectively filter out of band signals, reduce noise and increase dynamic range. 3、[GOOD SUPPRION] Good supprion of out of band remote signals, better than products made with PCB bare boards. 4、[ALUMINUM ALLOY] Using aluminum alloy shielded shell, has l interference and no out of band spurious response. 5、[SMA INTERFACE] The bandpass filter interface is SMA？M and SMA？F, both ends are symmetrical and there is no directionality. Specification: Item Type: Band Pass Filter Material: Aluminum Alloy Model: FBP-5060 Impedance: 50Ω Center Frequency: 5500MHz 3dB Passband: 4900-6100 MHz Insertion Loss: between2.5 dB at 5100-5900 MHz Maximum Carrying Power: 5W (37dBm) at 1 minute Interface: SMA-M, SMA-F (RF characteristics are symmetrical at both ends, no directionality) Package List: 1 x Band Pass Filter Note: Do not overload to use. Package List 1 x Band Pass Filter