Features: Designed for 12V 4-wire PWM fan/pump.Built-in DC-DC booster circuit. This PWM Speed controller support 12v standard fan speed control, also support computer water cooling PWM pump head speed adjustment. This governor is recommended to control the output power within 7-8 watts (12V 0.6A) This governor input port is USB Type-c female.Output is standard PWM 4pin fan port Built-in DCDC boost circuit(boost USB 5V to 12V).Built-in pwm signal generator ( to adjust speed)<br><br>Fan speed adjustment range 0-100% Turn the knob clockwise to increase the speed Turn the knob counterclockwise to reduce the speed Turn counterclockwise to close the output The application scenario of the governor design is mainly powered by the charging head/rechargeable battery, the common output capacity is generally 5V/2A, higher specifications are relatively rare, and the parameters of 12v/0.7A fan almost reach 5V/2A full power supply, while taking into account the small size of the PWM governor so limited cooling capacity. It is recommended that the output current be controlled 0.7A for short time use and 0.5A for long time use. Here means the current at the maximum speed, the fan current will vary proportionally according to the speed. Specification: Input voltage: 5V Output voltage: 12V PWM frequency: about 25KHz Output current: rated 0.5A/maximum 0.7A Input port: USB TYPE-C female port Output: PWM 4Pin Speed range: PWM duty cycle 0-100% type: A-1 to 3 Adapter cable Material: PLA colour: Black<br><br>Package Contents: 1 x PWM Governor 1 supply Cable 1 x 1 to 3 Adapter cable<br><br>Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.