Feature: 1. Improving Adhesive Strength: This plasma surface treatment machine can improve the adhesive strength, for example, the adhesive strength of PP material can be increased several times after treatment, and the surface of most of the parts can reach more than 60 dyne after treatment. 2. Stable Surface Performance: The surface performance after treatment with this plasma surface treatment machine is durable and stable for a long time. 3. Environmental Protection Without Pollution: The treatment of this plasma surface treatment machine is pollution free and meets the requirements of environmental protection. 4. Wide Application: This plasma surface treatment machine has a very wide range of applications and can be used for surface treatment of various polymers, metals, rubber, PP, silicone and other materials. 5. Excellent Aluminum Alloy Material: The shell of this plasma surface treatment machine is made of excellent aluminum alloy material, which is sturdy and wear resistant, not easy to corrode and high temperature resistant. Specification: Item Type: Plasma Surface Treatment Machine Material: Aluminum Alloy Input Power: AC220V 50HZ Spray Gun Diameter: Approx. 46mm/1.81in Maximum Power: 600W Nozzle Processing Width: Approx. 46-50mm/1.81-1.97in Frequency: 50Hz Input Air Pressure: ≥0.3Mpa Output Working Pressure: ≥0.15Mpa Length Of High Pressure Line: Approx. 2m/6.6ft Use Temperature Range: -10℃-+50℃. Package List: 1 x Plasma Surface Treatment Machine1 x Nozzle Part1 x Connection Cable1 x Manual Note: 1. The plasma equipment is a special equipment, please do not open the chassis without professional knowledge of personnel maintenance equipment. 2. The ground terminal of the machine must be reliably connected (earth) ground line. 3. The high voltage cable between the nozzle and the host should be natural, and cannot be bent at a large angle. 4. Pay attention to the protection of high voltage cable, to prevent sharp objects cut the insulation layer of high voltage cable.5. Do not touch the sprayed plasma inner flame. 6. The external control interface prohibits voltage input. 7. The machine must work for the required air source for the water free oil free compressed air, poor air source will cause damage to the plasma nozzle. 8. When there is no gas or gas flow is insufficient, the equipment will automatically shut down to protect. 9. please use the orange colored area in the middle of the low temperature plasma flame emitted from the nozzle, that is, from the nozzle 8mm to 12mm area. 10. Don't use this machine in a flammable and explosive gas environment.