Features:It is used to measure the dynamic state of the liquid flowing through the pipeline, such as: water, ethylene, ethylene glycol and other liquids that have no corrosive effect on copper.When flow rate exceeds set value, fluid drives blade and micro switch, the SPDT contact can connect a circuit and disconnect other circuit.Flow control value is adjustable, repeat action point is stable.Protection grade is IP54, the microswitch contact life is up to 100,000 timesPerfect for water treatment system, central air conditioning, water cooling unit.Specification:Model: HFS-25Control mode: Paddle Switch type: SPDTMaterial: 304 stainless steel body, copper connector, phosphor bronze bellowsConnector: 1" / 25mmMax.working pressure: 1.0MPaAmbient temperature: 0~60℃Liquid temperature: -10~100℃(Fluid without icing)Contact life: 1000000 timesMicroswitch Current: 15AWeight: Approx.416g/ 14.7ozPackage List:1 * Water Flow Switch5 * Paddle1 * User manualInstallation method:1. Open the flow switch2. The switch has been set at minimum flow rate. Turn the adjusting screw counterclockwise to increase the flow setting value.3. Press the target to check whether the micro switch can work normally. Excessive clockwise rotation of the adjusting screw may lead to the failure of the flow switch.4. After the installation, please press the lever of the flow switch several times to check. If there is no "click" sound, turn the adjusting screw counterclockwise until there is "click" sound.5. The adjustment screw of lacquer seal is only used for the first time to adjust the state of flow switch. Please do not change or adjust it.6. Observe three operating cycles to ensure that the switch and the system to which it is connected are operating properly and cover the switch enclosure promptly.Note:1. Please check the flow switch carefully before installation.2. Flow switch can be installed in horizontal pipeline or vertical pipeline with upward liquid flow direction, but not in pipeline with downward liquid flow direction. When installed in the pipeline with upward liquid flow direction, the gravity effect should be considered.3. HFS flow switch could not be used in the pipe which liquid temperature below freeing point.4. Arrester must be installed if quick-closing valve fixed downstream.5. When installing wiring, please pay attention to the following matters:(1). It is absolutely forbidden to impact the wrench on the switch base plate, which will lead to the deformation and failure of the flow switch.(2). When wiring or debugging, cut off the power supply.(3). When wiring, it is absolutely forbidden to adjust any screws other than micro switch terminals and grounding screws. And connecting the wire carefully, otherwise it is easy to make the micro switch itself position displacement, resulting in the failure of the flow switch;(4). Special grounding screws must be used for wiring, and installation screws cannot be removed.(5). The blade of the flow switch cannot contact with the inner wall of the pipe and other throttles in the pipe, otherwise the switch cannot be reset normally.