Features Applicable Scenario: Our Wind Turbine Controller Is Suitable for Small Solar Power Plant Systems And Various Wind Dc Power Supply Systems. Brake Start: When The Red Indicator Light of The Controller Is on, The Battery Is Fully Charged, And The Wind Turbine Automatically Brakes, Or The Brake Is Automatically Started Due to Overcurrent Protection. Fast Heat Dissipation: The Air Duct Is Deep And Adopts A Heat Dissipation Wind Tunnel with A Raised Design; Effectively Solving The Heat Dissipation Problem of The Controller Under High Current Charging Conditions; Safe And Stable Working Condition, Comprehensive Protection: The Controller Helps to Automatically Control The Charging of Wind Turbine Batteries. When The Battery Is Fully Charged, The Brake Can Automatically Take Effect. Fully Waterproof Protection With A Rating of Ip67 Or Above. Aluminum Alloy Material: Made of Premium Aluminum Alloy Material, This Wind Charge Controller Is Strong And Sturdy, Wear Resistant, And Has A Good Heat Dissipation. Specification: Item Type: Wind Turbine Controller Material: Aluminum Alloy Features: Automatic identification, charging, unloading overcharging protection, reverse connection protection, short circuit protection, high temperature protection, overload protection, fan current limiting, automatic braking Rated Working Voltage: 12V, 24V Rated Power of Wind Turbine: 600W Brake Start Voltage (Factory Value): 30V Brake Recovery Voltage (Factory Value): 27V Working Temperature and Humidity Range: -35 ℃ to 75 ℃ Static Power Consumption: Less than or equal to 15mA Protection Level: IP67 Display Method: LED (light emitting diode display) This controller can control the wind turbine to automatically charge the battery. Waterproof protection. This controller adopts a fully sealed and completely waterproof design, with a protection level of IP67 or above. Even when placed in water, it can be used normally for a long time, with significant stability and reliability. Application Area: Small solar power plant system Various wind DC power supply systems Package List: 1 x Controller Note: 1. Confirm that the output voltage of the wind turbine is consistent with the rated voltage of the battery.2. Connect the wires in the following order, first connect the positive and negative poles of the battery, and then connect the three phase voltage output of the fan.3. Please strictly follow the instructions to connect the battery and wind turbine generator to the controller. Reverse polarity or incorrect connection can contribute to abnormal system operation and even damage to the controller. Package List 1 x Controller