MPPT Wind Charge Controller 800W for 12V/24V Generators with Efficient Power Regulation

Wind Generator Controller 12/24V 800W MPPT Wind Charge Controller for Wind Turbine Systems Automatically charges the battery Features an integrated rectifier and brake circuit module, offering improved heat dissipation and reliability compared to traditional designs Fully sealed and waterproof design with IP67 protection rating, suitable for long-term operation in wet conditions Note: Ensure the wind turbine generator output voltage matches the battery's rated voltage. Connect wiring in the correct sequence: first connect the battery's positive and negative terminals to the controller, then connect the three-phase output from the wind turbine. Proper connection of the battery and wind turbine to the controller is required. Reversing polarity or incorrect connections may cause system malfunction or permanent damage to the controller. Wiring Instructions: 1. Connect the battery's positive and negative terminals to the corresponding red (positive) and black (negative) battery terminals on the controller. 2. Connect the wind turbine's three-phase output to the three-phase input (green wires) on the controller. Specifications: - Maximum input AC voltage: AC35V - Output voltage: 12V / 24V - Battery charging cut-off voltage: 14.5V ± 0.3V / 29V ± 0.3V - Maximum charging current: 15A (12V), 10A (24V) - Wind generator speed limit voltage: 14.5V ± 0.3V / 29V ± 0.3V - Protection level: IP67 - Static power consumption: 0.008A - Maximum load power: 800W - Maximum bearing wind speed: 12 m/s - Operating temperature range: -35°C to 65°C - Input wiring: Three-wire system - Control mode: Compatible with 12V and 24V systems - Installation: Bolted mount - Avoid reversing positive and negative terminals to prevent damage Application: Wind charge controller Color: Blue Material: Aluminum alloy Package Includes: 1 x MPPT Wind Generator Controller Note: Lighting and display differences may cause slight color variations between the image and the actual item. Measurement tolerance: +/- 1-3 cm.