The OBD II / EOBD code reader is designed for all OBD II compliant vehicles. The US environmental protection agency requires all vehicles and vehicles that were updated in 1996. A small number of 1994 and 1995 model year gasoline vehicles are OBD II compliant. If the vehicle is OBD II compliant, the label will designate OBD II Certified. Additionally, government regulations mandate that all OBD II compliant vehicles must have a common 16-pin Data Link Connector (DLC). For your vehicle to be OBD II compliant it must have a 16-pin DLC (Data Link Connector) under the dash and the vehicle emission control information label must state that the vehicle is OBD II compliant. Features:1. Support multi-brand car, works with all 1996 and later OBDII compliant US, European and Asian vehicles.2. Multi-language supported: English, French, Italian, Spanish, German, Dutch.3. Supporting shortcut key queries.(VIN,DTC)4. Support read/clear diagnostic trouble codes,I / M readiness,vehicle info,turn off the MIL (Check Engine light) an so on.5. Display current sensor data, including:6. Engine RPM7. Calculated Load Value8. Coolant Temperature9. Fuel System Status10. Vehicle Speeds11. Short Term Fuel Trim12. Long Term Fuel Trim13. Intake Manifold Pressure14. Timing Advance15. Intake Air Temperature16. Air Flows Rate17. Absolute Throttle Position18. Oxygen sensor voltages/associated short term fuel trims19. Fuel System status20. Fuel PressureMulti-Protocol Support:1. For SAE J1850 PWM (41.6Kbaud)2. For SAE J1850 VPW (10.4Kbaud)3. ISO9141-2(5 baud init, 10.4Kbaud)4. ISO14230-4 KWP (5 baud init, 10.4 Kbaud)5. ISO14230-4 KWP (fast init, 10.4 Kbaud)6. ISO15765-4 CAN (11bit ID, 500 Kbaud)7. ISO15765-4 CAN (29bit ID, 500 Kbaud)8. ISO15765-4 CAN (11bit ID, 250 Kbaud)9. ISO15765-4 CAN (29bit ID, 250 Kbaud)Specification:Display: Badit,128 x 64 pixel displayOperating Temperature: 0-60℃( 32-140℉)Storage Temperature: -20 -70℃(-4 -158℉)External Power: 8.0 to 15.0 Volts provided via vehicle batteryPackage List:1 x Car Scanner