M5GO IoT Kit V2.7 is a cost-effective entry-level development kit for the Internet of Things. The set includes the core controller M5GO and 6 expansion units with different functions (sensors/actuators/splitters). The core controller M5GO adopts the ESP32 chip and is equipped with two low-power Xtensa ® 32-bit LX6 microprocessor with a clock speed of up to 240MHz. Onboard 16M FLASH large memory, capable of accommodating larger program volumes While possessing strong hardware capabilities, this MCU also supports Wi Fi, which can be used to develop applications such as smart wearables and smart homes. Developed based on ESP32, 16M FLASH, Integrated full-color high-definition IPS display panel and various hardware peripherals, Rich resource interfaces, compatible with stack module system and sensor system, highly scalable The base opening is compatible with 8mm building blocks, and the structural construction is full of fun, for Verification Device Low code development: Support UIFlow graphical programming platform, scripting, compile free, cloud push Fully compatible with mainstream development platforms such as for and ESP32-IDF Support FreeRTOS, utilizing dual core and multitasking mechanisms to efficiently organize task logic and optimize program execution efficiency High integration: 2.0-inch IPS display panel, 6- IMU, programmable RGB lights x 10, microphone, speaker, custom buttons x 3 Built in lithium battery power supply, integrated power management chip, supports TypeC interface and POGO PIN interface power supply A professionally modulated circuit provides stable and reliable wireless communication quality Strong scalability: GROVE expansion port x3 (I2C, GPIO, UART) Easy access to 's software and hardware system, stackable module design, and plug and play sensor expansion Color: As Shown Material: ABS Package Contents: 1 x Development Kit Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.