["G5/8-14 CGA540 Oxygen Pressure Regulator O2 Pressure Reducing for Valve Flow Meter for Oxygen Inhaler Gas Regulator CGA-540\n\nFeatures:\n1.Main function is supporting oxygen supply system in center for emergency use.\n2.It adopts precision cutting to ensure the accuracy and tolerance of each part,equipped with oxygen meter accessories,which is convenient and practical.\n3.Fine workmanship and quality assurance,not easy to rust or fade,long service life.\n4.The gas is specially filtered and humidified to basically eliminate impure substances in oxygen,making oxygen more comfortable and safe.\n5.Oxygen inhaler decompresses the high-pressure gas in a steel cylinder into a low-pressure oxygen through a spring piston for human breathing.\n6.With complete accessories and easy to use,user-friendly design,non-toxic and odorless.\n\nSpecification:\nProduct name: Buoy type·oxygen inhaler\nInput pressure: <15Mpa\nOutput pressure: 0.25Mpa\nFlow adjustment range: 1-10L/min\nSafety valve: 0.5Mpa automatic exhaust\nImported thread: G5/8-14 (CGA540)\nOutlet thread: \nWith for tide bottle device\nSize:32x21x9.5cm\nQuantity:1pc\nMaterial:Zinc Alloy\n\nPackage includes:\n1* oxygen regulator (with complete accessories)\n\n--------------\nApplication\nMainly supporting the oxygen supply system in the community center, used for oxygen inhalation and hypoxia symptoms for oxygen inhalation, scientific research institutions, industrial and mining inhalation flow control devices. The oxygen inhaler has a precise flow rate, which is convenient and safe to use. Is a necessary device for oxygen supply\n\nWorking principle\nThe role of the oxygen inhaler is to provide continuous constant pressure and flow of oxygen for the patient to use. The bottle plug-in oxygen inhaler uses its own decompression device to reduce the high pressure (15Mpa pressure when the bottle is full) in the oxygen bottle to a low pressure suitable for the human body (0.2~0.2Mpa), and then output it to the human body after wetting the water . The input pressure of the wall-plug oxygen inhaler is 0.2~0.4Mpa, so it does not need to be decompressed, and can be directly output to the human body.\n\nMethod of operation:\n1. Add distilled water to the humidification cup. The water level in the bottle should not be higher than the upper water line, but not lower than the lower water line. It is forbidden to use saline instead.\n2. Before inserting the inhaler into the oxygen terminal socket, the flow adjustment switch should be turned off, and the direction of the oxygen quick plug should be adjusted, and then the quick plug should be inserted into the hole of the oxygen terminal socket. When you hear the \"click\" sound and see the oxygen terminal When the locking sleeve of the socket slides automatically, it means that the quick plug and the oxygen terminal socket are connected and locked.\n3. Insert the oxygen pipe into the oxygen connector before supplying oxygen, and then turn the flow adjustment switch counterclockwise to turn on the origin, so that the float rises slowly (the scale line aligned with the center of the float is the flow reading, the unit is liter/min) , Oxygen supply can be adjusted according to need.\n4. During the oxygen supply process of the inhaler, if the water in the inhaler bottle is lower than the water line, the flow adjustment switch should be closed in for time, the humidified bottle should be unscrewed, and distilled water should be added according to the requirements of Article 1 of this item. Screw on the inhaler bottle to continue oxygen supply.\n5. When the inhaler is stopped, the air source of the inhaler should be turned off; if it needs to be removed, the inhaler should be held by hand and then removed (the unlocking method of different oxygen terminal sockets is explained by the engineering installation unit), and then After the water in the bottle is cleaned and disinfected, store it in a non-corrosive and well-ventilated room)."]