The function of the tool setting instrument The measurement and compensation of the tool offset value in directions can effectively eliminate the error and inefficiency caused by manual tool setting. No matter what kind of cutting tool is used for workpiece contour turning or milling, all tool tip points or tool axis lines involved in cutting must be adjusted or compensated so that they are accurately located at the same theoretical or axis of the workpiece coordinate system on-How to use:1. clip is fixed on the cutter2. port has been connected to the control board (A5 interface on the 3018pro control board)3.Place (plastic + aluminum plate) under the toolmaterial: plasticColor as shownGRBL Z-probe Router Tool Setting Automatic Tool Setter. Thickness: 1.6mm (0.03mm)Tool Setting Function It can accurately locate the working surface, and is most suitable for PCB engraving.Easy to Use You can refer to video to understand how to use it correctly.Probe Please change the Probe in Grbl to: G91G21G38.2Z-30F100;G92Z1.6;G0Z5F10What does G91G21G38.2Z-30F100;G92Z1.6;G0Z5F10 mean:G91: Use relative coordinate modeG21: Use mm unitG38.2: Tool setting instructionZ-30: The Z axis moves 30mm in the negative direction, if it touches the tool setter, it will stop and set this as the originF100: the speed of the Z-axis when it is running;: , instructionG92: Coordinate offset, because the tool setter has a thickness, in order to remove the thickness of the tool setter, you need to set the offsetZ1.6: Z-axis offset 1.6, 1.6 is the thickness of the tool setter, which is subject to the actual measured thickness of the tool setter;: , instructionG0: fast movingZ5: The Z axismoves to the position of coordinate 5, which is convenient for taking out the tool setterF10: Z-axis upward movement speedPackage Contents:1 x Z-Axis Router Touch Plate setOnly the above package content, other are not included.Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.