User interface:    * Display resolution 320*240 pixels  * Screen diagonal 2.8"  * 16 bits per RGB pixels  * Resistive touch control  * Jog switch control  * USB serial port control  * Optional TTL USART port (SW not yet implemented) on the internal PCB  * Linear power supply to avoid switching noise.    The input/output specification of the tinySA is split over the 4 modes       Low input mode spec:        * Input frequency range from 100kHz to 350MHz     * Input impedance 50 ohm when input attenuation set to 10dB or more.     * Selectable manual and automatic input attenuation between 0dB and 31dB in 1 dB steps     * Absolute maximum input level without attenuation of +10dBm     * Absolute maximum input power with 30dB attenuation of +20dBm for short period     * Input Intercept Point of third order modulation products (IIP3) with 0dB attenuation of +15dBm     * 1dB compression point at +2dBm with 0dB attenuation     * Power detector resolution of 0.5dB and linearity versus frequency of +/-1dB     * Absolute power level accuracy after power level calibration of +/- 1dB     * Lowest discernible signal using a resolution bandwidth of 30kHz of -102dBm     * Frequency accuracy equal to the selected resolution bandwidth     * Phase noise of -90dB/Hz at 100kHz offset and -115dB/Hz at 1MHz offset     * Spur free dynamic range when using a 30kHz resolution bandwidth of 70dB     * Manually selectable resolution filters of 3, 10, 30, 100, 300, 600kHz. Automatic selection of one of the 57 resolution filters.     * On screen resolution of 145 or 290 measurement points.     * Scanning speed of over 1000 points/second using largest resolution filters.     * Automatic optimization of actual scanning points to ensure coverage of the whole scan range regardless of the chosen resolution bandwidth     * Spur suppression option for assessing if certain signals are internally generated or actually present in the input signal        High input mode spec:        * Input frequency range from 240MHz to 960MHz     * As there is no input bandfilter strong signals outside the 240MHz to 960MHz range can cause distortion of the in band signals     * Absolute maximum input level without attenuation of +10dBm     * Input Intercept Point of third order modulation products (IIP3) of -5dBm  * 1dB compression point at -6dBm with 0dB attenuation  * Power detector resolution of 0.5dB and linearity versus frequency of +/-1dB  * Absolute power level accuracy after power level calibration of +/- 1dB  * Lowest discernible signal using a resolution bandwidth of 30kHz of -115dBm  * Frequency accuracy equal to the selected resolution bandwidth  * Spur free dynamic range when using a 30kHz resolution bandwidth of 50dB  * Selectable (automatic and manual) resolution filters of 3, 10, 30, 100, 300 and 600kHz  * Optional 25dB to 40dB frequency dependent input attenuator. The power level error with this attenuator activated increases to +/- 15dB  * On screen resolution of 145 or 290 measurement points.