For RPi Pico Flexible Microcontroller Board Dual Core 264KB ARM Cortex M0+Processor with SD2SP2 SDLoad SDL Adapter Blue

Features 1.HIGH PERFORMANCE: Microcontroller board is a microcontroller board based on the for RPi RP2040 microcontroller chip. Low cost, high performance with a flexible digital interface featuring two ARM Cortex M0+ cores up to 133 MHz; 256 kb of RAM; 30 GPIO pins; and a wide range of interface options. 2.ADAPTER: For SD2SP2 SDLoad SDL adapter allows the Micro storage card to be inserted into serial port 2. Launch your game or individual backup from the second serial port for lag free full motion video and improved read in of the serial port adapter, for SWISS code improvements allow for better read in times used as serial port, game faster loading speed. 3.SOFTWARE SUPPORT: For RPi Pico flexible microcontroller board has rich and complete software support, it comes with full compatibility with for RPi official C C++ SDK, Micro python SDK, it also comes with 16MB of on board QSPI flash memory for code and data storage. Maximum operating current is up to 500 mA. 4.USB TYPE C INTERFACE SUPPORT: For Castellated modules allow direct soldering to the carrier board, one touch reset button function for quick and easy access; low power sleep and hibernation modes; drag and drop programming via USB using mass storage. 5.MULTIPLE INTERFACES: For RPi microcontroller module has 26 x multi function GPIO pins, 22 x SPI, 2 x I2C, 2 x UART, 3 x 12 bit ADC, 16 x controllable PWM channels, on chip precise clock and timer, temperature sensor, accelerated on chip floating point library, 8 x programmable I/O (PIO) state machines, custom peripheral support. Specification Item Type: For RPi Microcontroller Board Material: PCBA Board Size: Approx. 5.1x2.1x0.4cm / 2.0x0.8x0.2in Interface: USB C Processor: Dual Core for Arm Cortex M0+ Processor Chip: for RPi RP2040 Microcontroller Chip On Board Flash Memory: 16MB SRAM: 264K Maximum Operating Current: 500mA for SD2SP2: Micro Storage Card Features: Official For RPi Pico Module Easy To Install, Only 5 Wires Needed For Soldering Detailed Soldering Tutorial And Video Instructions Programming Via USB Cable, No Drivers Or Programs Required Automatically Launches Any DOL Application Of Your Choice (Switzerland) Uses The "IPL Injection" Method Which Is Superior To Mods Like for XenoGC Complete Replacement For XENO+SWISS Boot Disk Method Of Operation 26 x Multifunction GPIO Pins 2 x SPI, 2 x I2C, 2 x UART, 3 x 12 Bit ADC, 16 x Controllable PWM Channels Package List 1 x for Picoboot Development Board Copied Program 5 x Electronic Wire 1 x Heat Shrink Tube 1 x Plastic Bracket 1 x Double Sided Adhesive 4 x Silicone Film 1 x for SD2SP2