Feature:1. EASY TO USE: The FM_ANT port of the FM receiver module is used to connect the FM antenna. For better reception of FM signals, it is recommended to connect an external 75cm length trolley antenna.2. SPEAKER FUNCTION: The digital FM radio module comes with a 3W x 2 channel sound amplifier, so if you need speakers, you can plug them into the speaker port. Practical and convenient.3. HEADPHONE FUNCTION: The digital FM receiver module automatically switches to the headphone channel if headphones are plugged in, and the speaker channel is automatically started up.4. AUTOMATIC SEARCH: FM radio module is simple and short to operate, press the encoder to automatically search for local radio stations, adjust the receiving frequency, the LCD screen shows the current frequency, the search stops when a valid station is found.5. TURN ON OR OFF: Press and hold the VOL knob to switch the FM radio module on or off, the LCD display shows the caption ON to turn on the automatic noise, OFF to turn off the automatic noise.Specification:Item Type: FM Receiver ModuleMaterial: PCBInterface: For Android InterfaceOperating Voltage: 3.0-5.0V.Package List:1 x FM Receiver Module 2 x Washers 2 x Nuts Note:1. MuteShort press VOL knob down to switch between mute, non mute2. Automatic squelch switchPress and hold the VOL knob down to toggle the Auto Squelch function on or off, the LCD display caption ON means Auto Squelch is on, OFF means Auto Squelch is off.3. Self acting noise threshold (threshold) adjustment (valid when the switch is on)Press and hold the knob downwards to enter the Auto Squelch threshold adjustment interface, rotate the VOL knob to adjust the action threshold of Auto Squelch according to the specific usage, the adjustment range is 031, the larger the value the higher the threshold, the easier the weak signal will be muted. The opposite is true.4. Connected to the serial port (no need to connect without serial control)The module is reserved for TTL level serial port control interface, TTL serial port communication with this module needs to connect the module's UART_RX, UART_TX and GND (marked on the corresponding position of PCB), you can use external MCU (microcontroller) or computer serial port to send commands to control the relevant functions of the module.5. Automatic station searchShort press the encoder to automatically search for local stations, while the LCD screen displays the current frequency, and stops when a valid station is searched.