1The floor electrical outlet has EU standard interface, the maximum carrying power is 4000W, suitable for offices and commercial buildings. 2Embedded installation design, the wires are not exposed, which can reduce the wiring clutter of desktop and floor. 3The panel is made of aluminum alloy, which is light in weight and corrosion resistant, and has good airtightness. 4The bottom box is made of PC flame retardant material, which is resistant to high temperature and can prevent disconnection or leakage. 5The floor electrical socket is damped and can be slowly popped up and opened, making it safer to use. Item Type: Floor Electrical Outlet Panel Material: Aluminum alloy Bottom Box and Functional Parts Material: Flame retardant PC Rated Voltage: 250V Rated Current: 16A Maximum Carrying Power: 4000W Protection Level: IP40 Installation Method: Embedded Use Scenario: Office desk, floor, business office building, residence, factory Panel Size: Approx. 226 x 118 x 3mm / 8.9 x 4.6 x 0.1in Bottom Box Size: Approx. 223 x 108 x 70mm / 8.8 x 4.3 x 2.8in 1 x Bottom Box 1 x Socket Panel 1 x Connector 2 x Cable Tie 6 x Mounting Screws 1. Be careful not to allow water to enter during installation, try to keep the desktop socket dry and clean to avoid potential safety hazards when using it in the future.2. Be sure to ground the wire when installing the desktop socket, so as to better protect the safety and service life issues.3. When installing the desktop socket, you must pay attention to the position, and it should not affect the normal use of the table. It is best to install it in a relatively clandestine place or a location that is not frequently used.4. After the desktop sockets are installed, be sure to test them one by one to see if they can be used normally. At the same time, pay attention to waterproof and moisture proof measures to avoid affecting future use.