Compatibility: 495209 for festool splinter guard replacement strip replace 495207 for festool splinter guard replacement strip and is compatible with for festool FS/2, FS/2 KP, and FSK guide rails & festool rail saws. Periodically replacing your splinter guard can keep your cuts perfectly splinterfree, especially if you are switching between , or using the guide rail with more than one saw.Function: You can replace the Splinter guard as needed to ensure perfect alignment of the guide rail with the cutting line, and to prevent tearing during parallel and lateral cutting. The new Splinter guard can perfectly match the saw blade, accurately align the cutting line, and save valuable setup time. Clear Splinter guard enhance visibility of the cutting line.High-quality: For festool splinter guard replacement stripis made of high-quality soft rubber, and uses strong adhesive, with a strong viscosity and high parency. It can tightly adhere to your guide rail without falling off easily.Easy to replace: As the splinter guard is cut into upon the first use, it reflects the exact cutting edge, meaning that it can be applied exactly at the scribe mark. You just need to remove the tape to use it. It's very simple. NOTE: You need to clean the rail with acetone and leaving surface grease free prior fitting the new splinter guard. NOTEOn a clean working surface, there is no risk of dust or debris getting on the tape.Pull off the adhesive strip or tape with the actual splinter guard to avoid sticking debris.Before installing the splinter guard, please use a shovel and acetone to remove remaining adhesive.When you re-apply the splinter guard, you can move it out a portion to allow for clean cutting.Colour:Photo ColorMaterial:plastic Package Contents:1 x Track Saw Guide Rail Only the above package content, other products are not included.Note: Light reflection and different displays may