Product Features 1. This product is made of environmentally friendly plastic material, and the part that fits the fuselage is protected by sponge; 2. This product supports a variety of camera installation methods, which can be installed on the top or on the bottom; 3. This product has a 1/4 screw connection and supports all panoramic cameras and sports cameras with 1/4 screw holes; Note: The mount is a niche product and is not recommended for novices. The product is a 3D printed custom product. Pay attention to the position when installing it. The screws need to be tightened (looseness will cause resonance shaking), but not too tight (too tight will explode). The storage and use temperature is -10~40 degrees. Do not store it in the car in summer. It is easy to cause deformation when it exceeds 60 degrees. The products sold are all accessories, not including drones, cameras, etc. Since the operation of each camera and operator is different, please be sure to use a short pole first when flying, and test the stability at low altitude. Our store does not bear any crash caused by any reason! Warm reminder: This product must be taken off and landed by hand or find a hollow frame in the middle as a take-off and landing support. Be sure to turn off the downward obstacle avoidance before operating! Product parameters Net weight: 45g Gross weight: 55g Dimensions: 20*8*3cm Packaging size: 21*8*4cm bag