This electric longboard skateboard control system has an EMP control module with a remote module, it can do whatever as ESC does, ESC would be easy to damage, this control module would be more stable and paper Made of high quality chip and electronic components, dual drive design can offer excellent and stable performance The solid structure of the main board can be significantly longer than the service life With a remote receiver module, so it supports remote control The well organized circuit board is easy to install but needs professional skills It comes with a portable controller, it has an economic shape, very compatible to hold and use 4 different speed modes: high speed sport mode, high speed economy mode, middle speed mode, low speed mode With an LED indicator that displays signal status, speed modes, battery percentage Features: Application areas: scouts, wheelbars, torsion cars, balance cars and so on The upgrade dual motor drive ESC is a double layer board and many better than other ESC Wireless 2.4G remote control transmission to control The maximum distance can reach 20 meters Also, have single/manual motor drive ESC for hub motor Support 5055/5065/6354/6374/6384 belt motor Protection: Overvoltage, Undervoltage, Overperformance, Stack, CW/CCW, Overcurrent, Speed Control Specification: Rated Voltage: 36V Current: 12A Rotate speed: 4200RPM Drive mode: Dual Motor Drive Max. speed: 35KM/H Power: 430W (36V) Weight: about 250g/8.82 ounce Max. Loaded: 120kg/264.55 lbs Remote distance: 20m/65.62ft (Max.) Sending method:: Hall Power connector: XT60 plug Hall interface: 5pin 2.0 connector Motor plug: 4mm Banana Size: approx. 18.5 x 10 x 5cm/7.28 x 3.94 x 1.97 inch Installations: 1: Connect the main control to the power supply 2: The power is turned on, wait for two seconds, then press and hold the key for about 6 seconds Wait until the switch indicator flashes 3: Turn on the remote control switch and use a small screendriver to press the button inside the small hole in the lower left corner of the remote control 4: The remote control is turned off for two seconds and then turned on. Wait for the remote control signal light and the switch signal light to flash at the same time to indicate that the match is successful Package includes: 1x ESC Substitute Control 1x USB to Micro USB Cable 1x LED Battery Indicator 1x 2.4G Remote Control Transmitter 1x Switch