1With low speed and high torque, good performance. 2Twoway communication, you can check the power of the scooter through the remote control. 3Multiple protections, with low voltage alarm function, undervoltage and power failure protection. 4The sinusoid solution makes it more stable than ESC and not easy to burn out. 5Suitable for scooters, unicycles, balance scooters. Item type:Scooter Controller SetMaterial: Electronic components + ABSColor: As picture shownWeight: Approx. 280gDrive mode: dual system driveInduction method: for hallController type and performanceController TypesOperating voltage rangeTotal power of controllerControl electric quantityT2 wireless dual driveDC voltage 36V/24V1300W2Control motor type and performanceMotor typeMaximum power of motorMotor speedCan not connect the motor for hallDC Brushless MotorWithin 650WWithin 8000 rpmcan not connectMaximum power: 430W (36V)Speed: 4200 RPMMaximum speed: 35KM/HPower connector: XT60 male plugCarrying weight: 120KGLong-distance distance: up to 20 metersProtection: overvoltage, undervoltage, overheating, stall, CW/CCW, adjustable speedCurrent: 12AVoltage: 36V, 10SRemote control built-in lithium batteryThe capacity of the remote control: 400MAHTotal length of remote control: Approx. 12cm/4.7inRemote control length: Approx. 6cm/2.4inCircuit board size: Approx. 10.5x8cm/4.1x3.1inApplication areas: scooters, unicycles, balance scootersNote: Different voltage, alarm voltage, protection voltage are differentSuitable for hub motor model airplane motor 5055 5065 6354 6364 6374 6384How to choose the right controller:1. Confirm the voltage of your battery6 series battery is 25.2V, 7 series battery is 29.4V, 10 series battery is 36V2. Confirm the motor typeExternal motor, chain, belt drive, use belt controllerHub motor, motor integrated wheel, please select the controller with the word hub3. Confirm single-drive dual-drive or four-wheel driveA controller drives a motor is a single driveOne controller drives two motors is dual driveOne controller drives four motors is four-wheel driveTaboo: Do not connect motor cables in parallel to allow single drive to drive two motorsElectric four-wheel scooter control system:Adopting the sinusoidscheme, the performance is more stable than the ESC, and it is not easy to burn outDescription of matching signal between remote control and main controller:1. Connect the main controller to the power supply.2. Turn on the power, wait for two seconds and then press and hold the key for about 6 seconds, let go when the switch indicator flashes.3. Turn on the remote control switch and use a small screwdriver to press the button in the small hole in the lower left corner of the remote control.4. Turn off the remote control and turn it on for two seconds. Wait for the remote control signal light and the switch signal light to flash at the same time to indicate that the configuration is successful.About the motor for hall wire connection description:At present, the normal version and standard version of the controller need to provide conventional connection methods for the phase sequence. The brushless motor is controlled by 3 phases and 6 ways. 3 for hall states correspond to 3 motor wires and 6 output states. There are 36 connections for different combinations. , Among them, there are 6 kinds of connections that can make the motor run normally, and 3 of these 6 kinds of connections are forward rotation and the other 3 are reverse rotation.1.