Dual-channel H-bridge driver working mode provides higher efficiency. Features L298N as the main chip, capable of driving one 2-phase stepper motor, one 4-phase stepper motor, or two DC motors. To prevent damage to the voltage regulator, use an external 5V power supply when the driving voltage exceeds 12V. Equipped with high-capacity filter capacitors and freewheeling protection diodes to enhance reliability. Maximum operating voltage up to 46V, peak current up to 3A, continuous current up to 2A, and maximum power up to 25W. Specifications: Chip: L298N Control voltage: 5V Control current: 0–36mA Maximum power: 25W Drive voltage: 5V–35V Drive current: 2A per DC motor Operating mode: Dual H-bridge driver (supports two DC motors) Features: - Utilizes L298N high-voltage, high-current motor driver IC - High operating voltage (up to 46V), high output current (up to 3A peak), continuous current 2A, rated power 25W - 15-pin package with two built-in H-bridge drivers for driving DC motors, relays, solenoids, and more - Supports external current sensing resistor for feedback to control circuitry - Compatible with standard logic level signals with two enable control inputs - Allows power supply input control independent of input signals, enabling internal circuits to operate at lower voltages Compact size: 43 x 43 x 27mm Material: PCB Color: Red Package Contents: 2 x L298N Motor Drive Controller Board Module Note: Light reflection and display differences may cause slight color variations between the image and the actual item. Measurement may vary by +/- 1–3cm.