Diy Radio Kit Fm Stereo Radio Learning Patch Components Welding Assembly Production Kit

1. The YFM-2 type radio circuit is very simple. The number of components does not exceed 19. Although the number of components is not , it includes two types of components: SMD and DIP which are suitable for novices and friends who want to practice soldering of SMD components.2. Built-in digital automatic gain control (AGC) circuit. Support the global frequency band 76-108Mhz. DIY manual welding. Simple and easy to operate. Support radio memory function3. Item name: FM Stereo Radio Module DIY Kit. Item Mode:YFM-2. Work Voltage:DC 3V. Work Current:19mA. Output impedance:32ohm. Work Temperature:-40Celsius - 85Celsius. Work Humidity:0% - 95%RH. Size(Installed):57 x 32 x 20mm4. Applicable: Training welding skills. Student school. DIY production. Project Design. Electronic competition. Graduation design. Crafts collection. Home decoration. Souvenir collection5. Installation Tips: User needs to prepare the welding tool at first. Please be patient until the installation is complete. The package is DIY kit.It need finish install by user. The soldering iron can't touch the components for a long time(1.0 second), otherwise it will damage the components. Pay attention to the positive and negative of the components. Strictly prohibit short circuit. Install complex components preferentially. Make all components are in right direction and right place.Installation Steps(Please be patient install ):Step 1: Install 1pcs SOP-16 RDA5807PF at U1.There is a dot on one corner of the IC and there is a rectangle pad on PCB where the Pin1 of IC can place on.These two marks are corresponding to each other and are used to specify the installation direction of the IC.Step 2: Install 1pcs 30K ohm Resistor at R1.Step 3: Install 1pcs 0.1uH Inductor at L1.Step 4: Install 2pcs 1uH Inductor at L2,L3.Step 5: Install 1pcs32.768KHz Crystal Oscillator at Y1.Step 6: Install 1pcs 24pF Ceramic Capacitor at C1.Step 7: Install 1pcs 0.01pF(103) Ceramic Capacitor at C2.Step 8: Install 1pcs 0.022pF(223) Ceramic Capacitor at C3.Step 9: Install 5pcs 6*6*5mm Switch at S1-S5.Step 10: Install 1pcs 100uF 16V Electrolytic Capacitor at C4,C5. Please pay attention to the positive and negative poles. The shorter pin is the negative pole.Step 11: Install 1pcs 3.5mm Audio Jack at J1.Step 12: Connect battery box.Pay attention to positive and negative.Step 13: Use a cable tie to fasten the battery box.Step 14: Connect to supply and enjoy the effect.colour:As shownMaterial:Metal + plasticPackage Contents:1 x DIY radio kitOnly the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.