Digital Temperature Controller -40-110c Digital -digital Thermostat With Lcd Display NM9 EJV

[Simple to ]:The temperature range for this temperature controller is -40-110. Convenient to set and adjust, with HD LCD display and 4 buttons. It is a relay temperature controller, you need to additional supply for the load.[High Current 30A Relay]: High : 220V 30A. It is can be used high equipment, like refrigerator,brooder,incubator,Fermenter, Greenhouse,etc. supply and heating/cooling equipment, place the probe and set the temperature, it will work great.[Heating/Cooling Function]: Heating Mode 'H' : when the detection temperature less than equal set temperature - hysteresis temperature, the relay is turned on, and the heating equipment starts to work; When the detected temperature greater than equal the set temperature, the relay is disconnected and the heating equipment stops working. The principle of Cooling Mode 'C' is the .[Delay &Temperature Correction Function]: Delay 'OPH': When a heating or cooling job is completed, the system starts timing 'T'. When T greater than equal OPH, the system can the round of heating or cooling work. Temperature Correction 'OFE'(-10.0-10.0): When the system works for a long time, there may be deviations, which can be corrected by this function. Actual temperature = measured temperature + calibration value.[High Temperature Alarm Function]: When the actual temperature greater than equal the alarm temperature, the system will turn on the sound and light alarm and disconnect the relay, press any button to stop the sound and light. Steps:1. sensor to controller.2. to supply to controller.3. Adjust Temperature,Stop temperature and Temperature Correction.4. Remove supply.5. to load with supply at relay output terminal if need at Step5 in.6. to supply for controller again.7. Test and workingcolor:As shownMaterial:plasticPackage Contents:1 x XY-DT01 Digital Temperature ControllerOnly the above package content, other products are not included.Note: Light and different displays may the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.