Condition: Item Type: Orthodontic Dental Adhesive Optional Type: Large Set, Small Set Material: Plastic Service Life: 18 Months Storage Condition: Keep below 25°C (do not freeze) Suitable for: All kinds of dental orthodontic attachment adhesion Main Technical Performance Index: - Curing time not more than 300 seconds - Adhesive shear strength >17.2 MPa Usage: 1. Tooth preparation: Clean the enamel surface of the teeth, remove dirt, rinse thoroughly with water, isolate the teeth, and dry the surface with oil-free and moisture-free air. 2. Acid etching: Apply acid etching agent to the tooth surface, rinse thoroughly with water after 50–60 seconds, then dry. The etched surface should appear chalky. If not, extend the etching time. 3. Primer application: Apply a thin layer of primer to the etched tooth surface using a brush. Apply another thin layer to the bonding surface of the bracket (surface should remain wet). 4. Bonding: Apply a small amount of adhesive paste to the bracket base with a mixing rod to form a thin, even layer. Immediately place the bracket onto the tooth surface. Adjust position within 20 seconds and apply light pressure for 5–10 seconds to prevent movement. Remove excess material after 40–60 seconds. Allow to cure for 5 minutes before proceeding with orthodontic procedures. Features: - Designed for bonding various dental orthodontic attachments - Easy to use with minimal waste - Enables independent application - Provides high clinical bond strength - Efficient and convenient - Advanced enamel adhesive resin formulation - Complete accessory set - Available in two options to suit different needs