1This module is a 72V to 24V DC power converter, which is used for various buck voltage regulator equipment. 2When the protected circuit is at an unsafe value, the builtin protector automatically cuts off the circuit, and works normally when the value returns to the normal range. 3Using organic silicone potting technology, it is waterproof, dustproof and shockproof, suitable for various harsh environments. 4With automatic protection functions such as overcurrent, overvoltage, overheating, short circuit, etc., allround protection of the circuit. 5Used for surveillance cameras, electric fans, water pumps, motors, LED lights, security systems, audio equipment, industrial electrical equipment, etc. Item Type: DCDC Converter Material: Organic silicone + aluminum Model: GYVRM-JD1L722420 Input Voltage Range: 72V(DC60-90V) Output Voltage: 24V Rated Output Current: 20A Output Power: 480W Protection Level: IP67 Conversion Efficiency: Up to 96% Working Temperature: -20~+80 Installation Line Length: Approx. 13cm / 5.1in 1 x Power Converter 1 x Wiring Drawing 1. In order to ensure the normal operation of the converter within the input voltage range, the input voltage must not be lower than the minimum or maximum input value restricted by the product during use, and the input voltage value must be higher than the output voltage value by more than 2V. If there is no 2V voltage difference, the output value will be lower, but it will not damage (affect) use of the converter.2. The input current must be greater than or equal to the power required by the output load device (for example, if the power of the load device needs 100W, then the input power must be greater than or equal to 100W). When the converter is in use, the current of the load device should not be greater than the maximum current value that the converter can withstand, and leave as much margin as possible for the converter to ensure that the converter works normally and achieves the highest conversion efficiency.3. The positive and negative poles of the converter cannot be reversely connected during use. Reverse connection may cause damage to the converter. It is recommended to add a suitable fuse to the input terminal during use.4. The chip works in light load mode when there is no load, and the output voltage may vary within a certain range.