Item Type: LED Light Induction Kit Product Model: LTK01 Input Voltage: DC12V/DC24V Output Voltage: DC12V/DC24V Output Power: Single Step 15W, Total Power: 400W Ports: 32 Induction Head: 2 (AB) Protection Class: IP20 Signal Mode: Human Body Induction Control Method: Induction Control Control Range: Approx. 30 meter / 98.4ft Interface Type: For DuPont Interface Applicable Scene: Home, hotel, bar Insert the LED strips into the controller ports of the corresponding stair steps in sequence. For Example: The lamps on the first step are directly inserted into the interface 1 corresponding to the controller; the lamps on the second step are directly inserted into the interface 2 corresponding to the controller; the lamps on the third step are directly inserted into the interface 3 corresponding to the controller; and so on This controller has 32 ports. According to the actual situation, you can insert the required light strips in order and do not need to pay attention to the redundant ports. You can also add light strips later. Lamp Controller Interface: For DuPont interface, left +, right ? LED Stair Light Sensor Controller Operating Instruction: Number of Stair Steps Settings: Press and hold the Settings 2 button for 2s, the red light flashes, and then press the Settings 1 button to select the number of stairs to set. After selecting, release the hand for 5s and the red light will turn off, and the setting is complete. Lighting Speed Setting: Press and hold the Setting 1 button for 2s, the red light flashes, and then press the Setting 1 button to set the speed 1?5, 1 is the slowest, 5 is the fastest; The light goes out and the setting is complete. Brightness Settings: When the LED Light is on, press the Setting 2 button to enter the 5 level brightness selection lighting delay setting: Press and hold Setting 1 button for 3s, enter the delay settings 1?5 levels, respectively, the first level is a delay of 10s, the second level is 20s, the third level is 30s, and the fourth level is 40s, fifth level is 50s.