Features [Easy Motor Control] With just 3 input wires, this DC motor drive module allows for simple control of engine braking as well as forward and reverse rotation. [Dead Zone Control] The chip features built in dead zone hardware control, effectively protecting the H bridge during frequent motor direction changes, preventing direct damage, making software programming easier. [High Frequency Operation] Operating at a high frequency of up to 600KHz, this module is suitable for powering hollow core motors, with minimal noise and low heat generation. [Dual PWM Inputs] With two PWM inputs, the module operating cycle can be adjusted from 0 to 100.0%, not feasible with regular drivers. [Brake Capability] This module is equipped with braking force, allowing for precise speed control throughout the entire process. Specification: Item Type: DC Motor Drive Module Material: ABS Module Type: H bridge brushless DC motor drive module is suitable for high power DC motors of 12-36V Application: High power DC motor drive. The required turning voltage for wide input voltage (12-36V) is DC12-36V DC voltage. Output Current: 15A below 360W at rated continuous power 24V, no heat sink required, maximum 36V 15A 450W Output Power: Free cooling, nominal 450W, power supply 36V 15A Measurement Working Temperature: Industrial grade (-40℃ to 85℃) Full Load Temperature: 45℃ Package List:1 x DC Motor Drive Module 1 x Accessories Note:Prohibit AC power input. Package List 1 x DC Motor Drive Module 1 x Accessories