Advanced DC Brushless Motor Controller: Equipped with a Hall sensor, this controller is designed specifically for DC brushless motors with a 120-degree Hall sensor. It supports both PLC 0-5V analog and 2.5-5V PWM control, ensuring versatile and precise motor management. Ideal voltage range from 6-60V, with a peak current of 20A and power up to 500W. Efficient Connection Setup: Features five Hall interfaces for comprehensive connectivity. Includes two Hall power supply lines and three Hall signal lines, marked as Ha, Hb, and Hc, ensuring correct and easy setup. Match these with corresponding interfaces on the driver board for optimal performance. User-Friendly Operation: The controller board is marked with phase wire interfaces MA (U), MB (V), MC (W) for straightforward connections. Start with the main power supply, adjust the potentiometer throttle to about 20%, and experience smooth motor operation. Ideal for projects requiring reliable motor control. Safety and Maintenance Tips: Due to high power and current handling, avoid short-circuiting during setup. Start tests with low current and voltage to ensure safety. Insulate wiring properly to prevent any electrical hazards. Note that the board does not include a fuse; consider adding one to safeguard against power surges. Installation Cautions: Ensure correct polarity when connecting the power supply to prevent damage to board components. Do not use motors that exceed the voltage and power specifications of the drive module to avoid operational failures and potential damage. Color:As Shown Material:plastic Package Contents: 1 * Driver module Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.