The product adopts the simple modification method, namely the lossless appearance, and convenient operation, the installation is very simple The product material uses PET metal heating film, heating speed is very fast, a few seconds fast heat, safe and fast The product design adopts three gear adjustable switch, first gear, second gear, and turn off, which can arbitrarily adjust according to their own needs, and high and low temperatures, the design is very humanized The product switch adopts the rearview mirror fixed bracket design, which can be directly installed on the rearview mirror seat, no holes, no damage, very simple and convenient Products as long as the voltage is DC12V input motorcycle can be used, the use range is very wide Specifications: Product weight: 75g Product material: PET metal heating film Product size: length: 9.5cm; width: 8cm Input voltage: 12V Product power: 10W (single side), 20W (dual side) Handle temperature: low temperature: 30℃; high temperature: 50℃-60℃ Switch type: ship type waterproof, dust-proof switch Suitable models: all 12V motorcycle models Method of Installation: 1. Put the electric heat sheet on the handlebars and adjust it to the proper position 2. Attach (wrap) the electric heat sheet evenly to the handlebar, especially at the wiring point of the electric heat sheet 3. Set on the casing, adjust the position, and use the hot air gun (or lighter or hair dryer) to blow the two-fold of the coated pipe until the contraction is evenly, and then evenly blow other parts, until all parts of the coated pipe shrink evenly and smooth 4. The switch is installed under the rearview mirror rod 5. Connect the power cord, red line, and black line are not positive or negative but must receive the electric door lock (the key place) lower pole output line