Ceramic tile leveling system, 50 piece clip type ceramic tile leveling kit, ceramic tile leveling device with dedicated key, ceramic tile leveling reg

Tile Leveling System, 50 Piece Clip Tile Leveling Kit, Tile Leveler With Special Key, Tile Level Adjuster For Wall ConstructionPackage Includes 100 * Floor Kit for Tile Leveling System Features: 1. Wear resistant, recyclable, reusable. 2. Easy to use in DIY operation. 3. Balance the tiles in the same horizontal position. 4. Improve the speed of tile installation. 5. Reduce installer fatigue / pressure. 6. There is hardly any flat surface without cracks. 7. This reduces the need for sharpening and polishing. 8. Prevent shingles from moving during solidification. Features 1. Name: Tile Leveling System Floor Kit 2. Model: D91955 3. Equipment: High quality PP + stainless steel 4. Color: black + orange 5. Applicable Brick Difference: 2-6mm / 0.08-0.24 6. Applicable tile thickness: 3-16 mm / 0.12-0.63 Directions for use Lay the first tile leaving more than 2 mm (with crossed joints). Close to the tile. Insert the T-pins next to the space between the tiles. Then turn 180 degrees and the T-needle is attached to the bottom of both tiles. Adjust the cover by hand / special wrench until both tiles are level. After leveling for about 5-6 hours, before the cement / adhesive is completely dry, rotate the cover in direction reverse and pull out the T-needle 180 degrees until the soil is removed. Avoid not removing the T-leveling tile system 1. Ceramic tile joints are 2mm or more (cross joints are recommended) 2. When leveling, the adhesive cement or tile cement around the T-type leveler should be cleaned. 3. Remove the T-type straightener approximately 5-6 hours after leveling before the tile or cement binder is completely dry. Note 1. Due to the difference between monitor and lighting effect, the actual color of the item may be slightly different from the color shown in the pictures. Thank you 2. Please allow slight measuring deviation due to manual measurement.