Car Suv Ignition Switch 12v Rfid Keyless Entry Ignition Push Button Engine Start System Alarm Syste

Normal start: When the anti-theft state is released, step on and hold the brake pedal, short press start button once, the system will automatically start within 0.5 seconds, and the indicator light will be on after starting.Flameout: step on and hold the brake pedal, short press start button once, the system will automatically flame out, and the indicator light will be off after flameout.Long press to start: If it is not easy to start in winter or the engine is not in good condition, you can step on and hold the brake pedal and press the start button. Do not release the start button until car engine normally starts.Short press ON/OFF mode to switch: do not step on the brake, short press the start button once, then the first mode of is turned on, press the start button again, and the second mode is turned on. Press again to turn off the output. The above operations support manual cycle operations.1. One push button to start / stop the engine.2. RFID engine lock. In arming mode, when the key gets close to the detection circle(about 2-5cm), the system will sound Bi Bi, which indicates the system is disarmed. Otherwise, the start button will not work.3. Open acoustics and dashboard function.4. Automatically lock the host after stalling 35 seconds.5. Immobilizer, with warded lock card anti-theft function, the system will enter arming mode after 15 seconds automatically when car is stopped.6. Can be matched your car alarm system or keyless entry system.7. Suitable for all kinds of ,the 12V model is basically all right.8. Easy to install and remove.Specifications:Voltage: 12VColour: blackMaterial: ABSPackage Contents:1 x Host1 x Start Button1 x Start Harness1 x Detection Harness1 x RFID Sensor Ring2 x RFID Key1 x English ManualOnly the above package content, other products are not included.Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.