1. Surface cleaning: The pasting surface must be clean and dry. For general cleaning, 50% alcohol can be used to scrub and clean with solvent. On a clean surface, the solvent must be fully used before pasting. 2. Comparison position: Before pasting the product, the product must be placed (remember not to tear off the double-sided tape protective paper on the back) in the required installation area.Bit adjusted. Make sure the dimensions of the product installation location are consistent. When the temperature is lower than 20℃, the baby needs to be preheated first to achieve a better viscosity of the glue. 3. Product pasting: After confirming the position, peel off the adhesive paper behind the decorative sticker. Avoid contact between fingers and the adhesive surface during operation.Please press hard after pasting the product to full contact and moistening of the adhesive surface. Please do not tear it off repeatedly after application.Repost. 4. After pasting the product and parts, it is necessary to avoid contact with water and dust within 48 hours to achieve better adhesion. 5. Warm reminder: When installing, you must first adjust the required installation position with your car, and then use the glue to protect it.tear off the paper Type:Center Console Air Outlet Panel Fitment Type:Direct Install Fitment:For ES 2022- Colour:Carbon Fiber Pattern Material:ABS Package Contents: 1 x Center Console Air Outlet Panel Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.