Product Introduction: MKS CAN able V 2.0 module is an upgraded version of MKS CAN able V 1.0. CAN able 2.0 is a small, low-cost, open source USB to CAN analyzer. CAN able enumerates as a virtual serial port on your computer and acts as a serial line for the CAN bus interface.CAN able 2.0 supports standard CAN 2.0A, CAN 2.0B and CAN FD. / Under the premise of high-speed mission rate and high operational stability, the MKS CAN able V 2.0Pro module has stronger anti-interference ability and is very suitable for industrial debugging or Application in motor field. When using the candleLight firmware, CAN is enumerated as a native CAN interface on for Linux. The CAN able analyzer is compatible with for ARM-based embedded platforms, such as: for Raspberry Pi, for Raspberry Pi Zero, for O DROID, for Beagle Bone, etc., making it very suitable for integration into products. Product Features: 1. Support for CAN 2.0A, CAN 2.0B, baud rate up to 1M; 2. Support candleLight, sl can firmware, sl can initially supports CAN-FD, test rate up to 2M/5M baud rate; 3. The terminal resistor can be selectively enabled/disabled through the short-circuit cap; 4. Supports Type-C USB interface, online firmware upgrade and DFU mode firmware upgrade; 5. Uses high-performance ARM Cortex-M4STM32G431C8T 6 processor, operating frequency up to 170MHz; 6. Provided Schematic diagram, firmware and source code, host computer, etc. The information is complete and easy to use. analyzer board Version: V2.0 / V2.0 Pro Material: abs colour: As Shown Package Contents: 1 x usb data cable 1 x 3pin double Dupont cable 1 x analyzer board Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.