Feature:1. The measurement circuit is isolated from the incoming signal. Hall‑type current conversion, which can withstand 30 times the nominal input, prevents instantaneous high current access and burns out the internal components of the sensor, which is very safe2. Isolate the detection signal and the output signal, effectively filter the noise in the signal, greatly improve the signal-to-noise ratio and signal stability of the product, and effectively enhance the product's anti-interference ability3. The primary and secondary sides of the hole current transmitter are highly insulated and isolated, featuring high accuracy, small size, low power consumption, wide frequency response, and anti-interference characteristics4. Perforated input, no insertion loss, fixed with standard guide rail and flat screws, easy to install5. Especially suitable for generators, motors, intelligent low-voltage power distribution cabinets, air conditioners, fans, street lamps, power grid monitoring, motor signal monitoring, railway system signal monitoring industries and other load current intelligent monitoring systemsSpecification:Item Type: AC Current TransmitterMaterial: ABSPower Supply: DC24VInstallation Method: Standard rail + flat screw fixationProduct Use: Used to measure AC current, especially for power frequency 50Hz sine wave AC currentRated Current: AC0-5ARated Output: DC4-20mAAccuracy: 0.5%Overload Capacity: 30 Times the nominal inputTemperature Drift: ≤500PPM/℃Linearity: 0.1%Frequency Bandwidth: 20-5KHzCurrent Consumption: <15mA+ output currentResponse Time: <200msWorking Temperature: -109℃~+70℃Storage Temperature: 25℃~85℃.Package List:1 x AC Current TransmitterNote:Please do not use 250ohm or 500ohm to connect 4‑20mA output version of the transmitter to get 0‑5V or 0‑10V, this is a completely wrong method, you cannot get 0‑5V or 0‑10V signal, and it will make transmit becomes overheated or damaged.