for tubular garage roller shutters The EGD-01G is a control panel designed for metal roller shutter tubular motors. It operates on AC220V/50Hz and supports up to 20 rolling code remote controls (433.92 MHz). The controller also provides terminals for external push buttons, stop switches, and photocell safety sensors. With DIP switch settings, the board allows flexible configuration between single-button cycle mode or three-button split mode, as well as latch vs non-latch operation. It includes built-in fuses for motor and electronic circuit protection. Universal roller shutter motor control for tubular garage roller shutters The EGD-01G is a control panel designed for metal roller shutter tubular motors. It operates on AC220V/50Hz and supports up to 20 rolling code remote controls (433.92 MHz). The controller also provides terminals for external push buttons, stop switches, and photocell safety sensors. With DIP switch settings, the board allows flexible configuration between single-button cycle mode or three-button split mode, as well as latch vs non-latch operation. It includes built-in fuses for motor and electronic circuit protection. Color: As Shown Material: plastic Package Contents: 1* Rolling Door Motor Control Panel(No remote control included) Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.