600W DC DC Boost Converter Step UP Converter Module Power Supply 12V - 60V DC-DC Step Up Booster Converter Constant Voltage Features: 600W High power boost module Input voltage :12-60V or 8-16V Selectable Wide output voltage (12-80V) adjustable Output current (0.1-12A) Adjustable High efficiency Ultra-low dropout voltage Module parameters: Module Properties: non-isolated step-up module (BOOST) Input voltage: two input voltage ranges selectable (selectable with jumper on board) 1). 8-16V input ( In this input mode,please do not over-voltage input, otherwise it will burn module) 2). 12-60V input(default) Input Current : 16A (MAX) Please enhance heat dissipation when current over than 10A Static Current : 15mA (12V to 20V. The output voltage increase, the static current will increase a little) Output voltage: 12-80V (continuously adjustable) ( the default output about 19V ) Output Current : 12A MAX, if over 10A please enhance heat dissipation ( the higher the dropout voltage, the smaller the current ) Constant current range :0.1-12A Output power : = input voltage * 10A, such as: input 12V * 10A = 120W, input 24V * 10A = 240W, Input 36V * 10A = 360W, input 48V * 10A = 480W, input 60V * 10A = 600W. If you need more high-power, two modules can be used in parallel , for example if you need 15A output, then connect two modules in parallel ,the current of each module set to 8A then is OK. Operating temperature: -40°C to +85°C ( if temperature too high , please enhance heat dissipation) Operating Frequency : 150KHz Conversion efficiency : up to 95% ( affected by input voltage, output volage, current and dropout voltage ) Operating Ripple: about 100mV Load Regulation rate: about 0.2% Voltage regulation rate: about 2% Overcurrent protection : Yes ( input exceeds 17A, automatically reduces the output voltage , maybe have errors) Short-circuit protection: Yes (input with 20A fuse) double circuit protection, more safe. Input Reverse Polarity Protection: No , ( if necessary , input add one diode in series) Output prevent backflow : Yes, no need to add prevent backflow diode for charging . Installation: two 3mm screws Wiring: terminals, no welding. Size: 76mm(L) x 60mm(W) * 56mm(H, the height of the heatsink is included) Net weight: 205 g Applications: DIY a regulated power supply, only 12V input, output 12-80V adjustable. Power supply for your electronic device , according to your system can set the output voltage value . As a vehicle power supply, power supply for your laptop/PDA etc. DIY a laptop mobile power supply, with 12V high capacity lithium battery pack, travel no worry. Solar panels regulator. Charge for the battery. Drive high-power LED.