5V DC Trigger Relay Module for Arduino and Raspberry Pi

Product descriptionMaterial: Electronic materialOutput driver capacity: 250VAC-10A, 125VAC-10A, 30VDC-10A, 28VDC-10A;Easy to use, each output group has a simple 3-wire structure and 6 output terminals are reserved;The input is directly connected to the IO port of the single chip microcomputer or digital circuit, the high level input relay is energized, and the low level input relay is released; The working voltage is 5 V, the pick-up current is approx. 70 mA per channel and the relay status display is available;Full-chip components, reasonable driver circuit design, with 8050 three-tube drive relay action;Equipped with mounting screw holes for easy installation, the size of the circuit board is 1.8cm * 4.0cm * 1.9cm, and the weight is 15g;Quantity: 3-piece setPackage content: 3 * 1 relay module1. This microcontroller compatible board with 1 relay Output driver capacity: 250VAC-10A, 125VAC-10A, 30VDC-10A, 28VDC-10A; The 1-channel relay module is equipped with transistor and diode to switch higher loads safely, reliably and with little power. Thanks to its compact size, the 1-channel relay can be used in almost any project.2. The module is also equipped with a generously dimensioned relay in order to be able to reliably carry out many switching processes. The module can be safely installed in housings thanks to the practical drill holes.3. The channel of the module is also connected to an LED that indicates the switching status of the relay. The KY-019 relay is used to control AC circuits. The relay acts as a switch that responds to a signal. Because of this, it is widely used in IoT projects to control lights and other electronic devices.4. Relays are suitable for driving high power electronic devices such as lights, electric fans and air conditioners This relay module can be used to control high voltage with low voltage by connecting it to an MCU5. Controls DC or AC signals 220V AC load Working voltage: 5V; With operating display and signal output display