Feature:1. Edge location: The edge finder is designed to measure edges, holes, studs, angles, corners, etc. With high accuracy. 2. Flexible Applications: Supports online automatic measurement and also acts as an offline acoustic beam splitter in 5 directions. 3. Functions: connect GND and output signal line . After receiving the signal by the main computer, the macro program will realize the functions of automatic centering and coordinate recording. 4. Good material: adopting the highest quality aluminum alloy material, it probably does not deform, and also has high durability for long -term use. 5. Easy to install: Lightweight and compact, the installation of this touch probe is very convenient to do . . Edge Finder 3D Touch Probe Specification: Item Type: 3D Edge Finder Note on parameters Material 7075 Anodized Aluminum Alloy Surfaces Edge Finder Outer Diameter (Approximate) 39mm or 1.54inch Probe length (approximately) 20mm or 0.79inch, standard Can be replaced. Mounting diameter (approximately) 6 mm or 0.24 inch Handle length (approximately) Repeatability (approximately) 0.01 mm X and Y Swing axes (approximately) 3 mm or 0.12 inch Exceeding the stroke will cause damage. Z-axis Swing (approximately) 1.5 mm or 0.06 inch Exceeding the stroke will cause damage. Offline operation Yes It can be used as a photoelectric centering rod. Online work Yes It can be used with automatic centering system. Connection method Using the included data cable. 2m or ft , approx. Probe diameter (approximately) 2 mm or 0.08 inch IP43 Waterproof level Cannot work in coolant environment. Operating voltage 6-30 V Burns under pressure and cannot operate under low pressure. . Edge Finder 3D Touch Probe Package List:1 x 3D Edge Finder 1 x Connection Cable 1 x Key 1 x Storage . Edge Finder 3D Touch Probe