2pcs MQ-3 Alcohol Gas Sensor Module Ethanol Detector Breath Gas Detection Board

₹1,349.00
और मुफ़्त शिपिंग

2pcs MQ-3 Alcohol Gas Sensor Module Ethanol Detector Breath Gas Detection Board

  • ब्रांड: Unbranded

2pcs MQ-3 Alcohol Gas Sensor Module Ethanol Detector Breath Gas Detection Board

  • ब्रांड: Unbranded
RRP: ₹1,499.00
मूल्य: ₹1,349.00
आपकी बचत: ₹150.00 (10%)
द्वारा बेचा गया:
₹1,349.00
और मुफ़्त शिपिंग

स्टॉक में केवल 5 शेष हैं

हम निम्नलिखित भुगतान विधियाँ स्वीकार करते हैं

विवरण

2pcs MQ-3 Alcohol Gas Sensor Module Ethanol Detector Breath Gas Detection Board

Features 1.1. Using double-sided circuit board design, with power indicator and TTL signal output indicator. 2.2. With DO switching signal (TTL) output and analog output AO. 3.3. TTL output valid signal is low level. (When the output is low level, the signal light is on, it can be directly connected to the MCU or relay module) 4.4. Analog output voltage, the higher the voltage, the higher the concentration. 5.5. High sensitivity for the detection of alcohol gas. Specification Features: 1. Using double-sided circuit board design, with power indicator and TTL signal output indicator. 2. With DO switching signal (TTL) output and analog output AO. 3. TTL output valid signal is low level. (When the output is low level, the signal light is on, it can be directly connected to the MCU or relay module) 4. Analog output voltage, the higher the voltage, the higher the concentration. 5. High sensitivity for the detection of alcohol gas. 6. Rapid response and recovery characteristics. 7. There are four screw holes for easy positioning Detailed Test Parameters: Model: MQ-3 Detecting gas: alcohol vapor Detection concentration: 0.04-4mg/L alcohol Standard circuit condition: Loop voltage VC ≤24DC Heating voltage :VH 5.0±0.2V AC/DC Load resistance: RL adjustable Gas sensor characteristics under standard test condition: Heating resistor 31Ω±3Ω Heating power consumption: ≤90mW Sensitive surface resistance: 2KΩ-20KΩ (in 0.4mg/L alcohol) Sensitivity: Rs (in air) / Rs (0.4mg / L alcohol) ≥ 5 Concentration slope: ≤0.6 (R300ppm/R100ppm alcohol) Standard test conditions: 20℃±2℃; 65%±5% RH Standard test circuit: 5.0V ± 0.1V Warm-up time: ≥48 hours Electrical Properties: Input voltage: DC5V Power consumption (current ): 150mA DO output: TTL digital 0 and 1 ( 0.1 and 3.3V) AO output: 0.1-0 .3V, the highest concentration voltage is about 4V Note: After the sensor is powered, needs to warm up around 20S, measured data was stable , heat sensor is a normal phenomenon , because the internal heating wire , if hot is not normal. Wiring: 1. VCC: connected to the positive pole of the power supply 2. GND: connected to the negative power supply 3. DO: TTL switching signal output 4. AO: analog signal output Package list: 2 x Alcohol Gas Sensor Package List
  • Fruugo ID: 271672673-602234219
  • EAN: 9140150448558

उत्पाद सुरक्षा जानकारी

कृपया नीचे दी गई इस उत्पाद से संबंधित विशिष्ट उत्पाद सुरक्षा जानकारी देखें

निम्नलिखित जानकारी इस उत्पाद को बेचने वाले स्वतंत्र तृतीय-पक्ष खुदरा विक्रेता द्वारा प्रदान की गई है।

उत्पाद सुरक्षा लेबल

CE Mark
सुरक्षा चेतावनियाँ: Please do not allow your child to handle this product alone to avoid swallowing or other injuries; adult supervision is recommended.

डिलीवरी और वापसी

2 दिनों के भीतर भेजा जाएगा

  • STANDARD: मुफ़्त - के बीच वितरण बुध 10 दिसंबर 2025–मंगल 16 दिसंबर 2025 - मुफ़्त

चीन से शिप हो रहा है।

हम आपके द्वारा ऑर्डर किए गए उत्पादों को पूरी तरह से और आपके विनिर्देशों के अनुसार डिलीवर करने की पूरी कोशिश करते हैं। हालाँकि, यदि आपको अधूरा ऑर्डर या आपके ऑर्डर से कोई अलग आइटम प्राप्त होता है या किसी अन्य कारण से यदि आप अपने ऑर्डर से संतुष्ट नहीं हैं तो आप ऑर्डर या ऑर्डर में शामिल कोई भी उत्पाद वापस कर सकते हैं और आइटम के लिए पूर्ण रिफ़ंड प्राप्त कर सकते हैं। सम्पूर्ण वापसी पॉलिसी दिखाएँ