Easy to InstallProvided rounded rectangle raised label to easily peel off the red release film of the adhesive pads. When using, first easily peel off the white release film, stick the adhesive to the dashboard pad mounting disk or to the suction cup base directly, then peel off the other red side film and stick to your car dashboard. Press down repeatedly to increase the contact of the adhesive with the substrate. please wait 24 HOURS to use.6Pcs Clear Adhesives Replacement offers 6 Pcs round clear sticky adhesive pads(Diameter: 80mm,3.15") for attaching dashboard pad mounting disk of your suction cup dashboard phone mount. You can also adhere the transparent adhesive to the suction cup directly, not affecting the look of the suction cup.Easy to UseTo maximize adhesive contact, please clean the adhesive surface before use and let it dry, free of contaminates. And wait at least 24 hours to use after stuck. First peel off the white side of the adhesive and stick it to the car mount base. After applying some pressure on the adhesive, peel off the red film side of the adhesive and stick the car mount to your dashboard/ windshield.Cut into any size you need and Compatible With Suction BaseYou can cut pads into smaller pieces if need. Compatible with most suction cup dashboard mount and other windshield long arm mount, GPS holder, EZ Pass/I-Pass/SunPass holder, camera mount, ETC, wireless charger base, dash camera mount holder etc on the market.Very High Bond and Easy to RemoveThese high-strength, double-sided adhesive pads let you quickly and easily create a long-lasting bond, bonding almost instantly with no drying time. It also resists heat and moisture, and protects adhesive surfaces against scratches, easily peels off without leaving any sticky residue behind.