Fits virtually all vacuum sealers, as well as most models of hand / impulse heat sealersReplaces deteriorated or burnt-out PTFE tape, which is a crucial barrier between the heating elementsand the bag. Old tape causes poor bag sealing and can lead to a broken heating elementsand a broken sealerTape may be slightly wider and longer than necessary, allowing for broad compatibility. Strip should be replaced when appearing warn, discolored or if sealing isn't perfectJust peel tape from the roll and place on the correct area (you may need to clean the strip location before placing the new piece of tape). Over the wire for vacuum sealers, under the wire for impulse sealers[Wide Compatibility]Compatible with Vacuum, hand or impulse heat sealers. Fits almost all of for , , Seal A Meal, Cabella's and Nesco vacuum sealers. Perfect fits for models including FM2000, FM2100, 2240, 2440, 2244, 2450, 2840, 2860, 3240, 3460, 3835, 3840,3880, 4440, 4800,4865. GameSaver, Professional etc.. Great for Pro 2100, 2300 and more.Comparing with common tape, this PTFE tape is more heat and cold resistant. it has good effect in insulation for high voltage; there is no chemical reaction for chemical medicines or agents and solvents; It possesses resistance for light, oxygen, wear-resisting, anti corrosion, unordinary smoothness, good paste ability and other advantages.Colour:Light brownMaterial: PTFESize:Width: 1.3cmthickness: 0.13mmlength: 10mPackage Contents:2 x roll PTFE Fabric TapeOnly the above package content, other products are not included.Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.