Features 1.The module uses high-quality relay, the maximum load of the normally open interface: AC 250V/10A, DC 30V/10A. 2.Using patch optocoupler isolation, strong driving ability, stable performance; trigger current 5mA. 3.The module working voltage is available in 5V, 9, 12V, 24V. 4.The module can be triggered by a jumper to set a high level or a low level. 5.Fault-tolerant design, even if the control line is broken, the relay will not move. Specification Features: The module uses high-quality relay, the maximum load of the normally open interface: AC 250V/10A, DC 30V/10A. Using patch optocoupler isolation, strong driving ability, stable performance; trigger current 5mA. The module working voltage is available in 5V, 9, 12V, 24V. The module can be triggered by a jumper to set a high level or a low level. Fault-tolerant design, even if the control line is broken, the relay will not move. Power indicator (green), relay status indicator (red). The interface design is user-friendly, all interfaces can be directly connected through the terminal block, very convenient. Specification: Module Size:50 x 41 x 18.5mm / 1.97 x 1.61 x 0.73in Hole Diameter: 3.1mm/0.12in Hole Interval Distance:44.5 x 35.5mm / 1.75 x 1.4in Wiring Diagram: DC+: Connect the positive pole of the power supply (the voltage is required by the relay, there are 5V.9V.12V and 24V selection). DC-: connected to the negative pole of the power supply. IN1:1 signal signal trigger terminal, you can set the high or low level control relay to pull in. IN2: 2 channel signal trigger terminal, you can set the high or low level control relay to pull in. Relay output: NO1: 1 channel relay normally open interface, the relay is suspended before the suction, after the suction and short circuit with COM1. COM1:1 channel relay common interface. NC1: 1 channel relay normally closed interface, short circuit connection with COM1 before the relay is closed, suspended after suction. NO2: 2 channel relay normally open interface, the relay is suspended before the suction, after the suction and short circuit with COM2. COM2: 2 channel relay common interface. NC2: 2-channel relay normally closed interface, short-circuit with COM2 before the relay is closed, and float after the suction. High and low trigger selection: 1. S1 is a high-low trigger selection for 1 relay; 2. S2 is the high and low level trigger selection of 2 relays. 3 com is shorted with low, the corresponding relay is triggered by low level, and when com is shorted with high terminal, it is triggered by high level. Package List: 1 x Module Package List