Feature: 1. Fast Preheating: The motorcycle grip heated pads are heated quickly, with heated pad you will feel warm quickly while you are riding. 2. Temperature Control: Built in intelligent temperature control chip, five speed adjustable temperature, more convenient for using. 3. Excellent Performance: Heated grips handlebar with IP67 waterproof, abrasion resistant, tear resistant, anti aging, alkali resistance. 4. Easy Installation: The heating piece is fixed by straps, convenient and quick to install, and does not damage the handlebars. 5. Widely Use: Heated grips warmer pad widely used for most 12V motorcycles, ATV, scooters etc. Specification: Item Type: Motorcycle Handlebar Heated Pad Material: Fabric: Pure PVC; Bandage: Polypropylene; Heating Sheet: Composite fiber heating wireInput Voltage: DC12VOperating Voltage: DC 12.2V(Because this product has anti-loss protection, lower than 12.2V, the product cannot be used)Operating Temperature: -30°C - +100°CPower And Temperature Control Values: First gear (red) : 18W/85°C; Second gear (orange) : 14W/75°C; Third gear (yellow) : 10W/60°C; Fourth speed (green) : 8W/55°C; Fifth gear (blue) : 6W/50°C(The above data are obtained from the experiment, the specific value or due to the change of voltage, environment and other objective factors slightly fluctuate, for reference only)Strip Fuse: 5A. Package List: 2 x Motorcycle Handlebar Heated Pad1 x Adhesive5 x Cable Ties2 x Binding Wire1 x Bracket1 x Connecting Line1 x Instructions Note: (1) Please select an appropriate gear according to the ambient temperature. Under low temperature conditions, if the temperature of the electric handle sleeve cannot be timely and accurately sensed due to numbness and numbness of the hand, please use the low or medium gear first to prevent high temperature scalding. (2) This product is only suitable for motorcycles with 12V battery. Please confirm the voltage of your car and read the installation diagram carefully before installation. Incorrect voltage and wiring mode will cause damage to parts. (3) This product can only be installed on the motorcycle handle power use, before installationm can first use a battery to test whether the product is energized correctly.(4) It is strictly forbidden to work with electricity (empty burning) when not riding, in order to prevent the excessive temperature of the electric handle sleeve from damaging the original handle. (5) Wiring is recommended to connect the electric door lock wire. Most models are black positive pole and green negative pole. In specific cases, it is recommended to use a multimeter to measure.