Feature:1. Corrosion Resistant: Using good quality stainless steel protective shell, safe and reliable, corrosion resistant, sturdy2. Accurate Control: Come with simple operation, intelligent adjustment, wide control range, complete functions, accurate control3. Low Power Consumption: This dehumidifier have simple appearance, low power consumption, low noise communication4. Widely Used in Electrical Equipment: Widely used in electrical equipment such as control cabinets, high and low voltage switch cabinets, ring network cabinets, mechanical control cabinets, etc.5. Good Dehumidification Effect: Using the semiconductor refrigeration and dehumidification method, the water vapor in the air is condensed into water through the semiconductor refrigeration mechanism, and then passes through the duct discharge cabinet, which can achieve a good dehumidification effectSpecification:Item Type: Intelligent Dehumidification DeviceMaterial: Stainless steelInput Specifications: 1 Channel temperature and humidity input moduleWorking Current: 1AWorking Environment: Temperature: 0-50, Humidity: 85%RHRMeasuring Range: Temperature: 0~80, Humidity: 0~99%RHOutput Specifications: 2 Relay outputs, 220VAC/8A 30V/8AResolution: Temperature: 0.1, Temperature: 0.1%RHBasic Error: Temperature: 0.5, Humidity: 3%RHTotal Power: 50W, Cooling Power: 40WDehumidification Capacity: 5m Cabinet body24H Water Volume: 300ML under the condition of 30/80%RHControl Method: Automatic, manualInstructions: 1. The "Power" indicator light is always on after power on.2. Click the "Mode" button to switch between manual mode and automatic mode, and the corresponding mode indicator lights.Manual mode"Dehumidification/-" key is the dehumidification control key, click to open or close."Heating/+" button is the heating control button, click to turn on or off.The "Ventilation or Function Selection Settings" button is the ventilation control button, click on or off.Automatic modeThe "Dehumidification/-" key is a negative value button.The "heat/+" key is a button for adding values.The "Ventilation or Function Selection Settings" button is a function selection button.(1). Click to enter the dehumidification "-C-" setting interface, and set the humidity level through the plus and minus keys. When the actual humidity is greater than (set value +1), the dehumidification function is turned on, and the dehumidification function is less than (set value -2).(2). Click again to enter the heating "-H-" setting interface, and set the temperature through the plus and minus keys. When the actual temperature is less than (set value-2), the heating function is turned on, and when the actual temperature is greater than (set value +1), the heating function is turned off.(3). Click again to enter the ventilation "-F-" setting interface, and set the temperature through the plus and minus keys. When the actual temperature is greater than (set value +1), the ventilation function is turned on, and when the actual temperature is less than (set value -2), the ventilation function is turned off.(Note: The ventilation and heating function requires additional functional modules, only built in switch relays).Package List:1 x Host 1 x Temperature Probe1 x Drain Pipe1 x Rail2 x Screw1 x User Manual1 x PlugNote:1. Be careful not to cover the heat dissipation holes and ventilation holes around the body, otherwise will reduce the performance and the machine will not run smoothly.2. Do not pour water on the bottom of the motherboard and above the motherboard, it is easy to cause short circuit damage to the machine.3. If you do not use it for a long time, please clean the water inside and store it in a cool, ventilated place.4. If the sensor is damaged or has poor contact, the temperature and humidity displayed by the dehumidifier are both 0.5. Be sure to disconnect the power before wiring.