Characteristics: 1. Adopting high transparent environmentally friendly PET material as the base material, to better see the markings in the model markings. 2. DSP IAE's unique printing technology: a scale ruler is printed on the surface of the marking tape at a distance of 1mm, which is convenient for positioning when marking. 3. Special thickened material: It can be seamlessly attached to various model parts, there is no degumming and glue residue. 4. Double-layer hot-melt adhesive: the printed scale line is placed between the bottom and top layers of tape, and the two layers of tape are fused together by the unique hot-melt adhesive technology, so the scale line will not fall off and will not be scratched by external force. 5. Multiple sizes of engraving tape to meet more engraving needs. Combining the engraved lines will have a better effect. The special acrylate adhesive is used as the adhesive material, which becomes stronger when stuck on and leaves no adhesive residue when torn off. 6. Strong ductility and viscosity: It can also be used freely on curved surface model parts, and the tape will not fall off due to insufficient adhesion. Instructions: 1. First prepare the parts to be engraved. First design the routing with a pencil. After you have determined the engraving position point, use a carving knife or scriber to mark the position point. 2. Cut a piece of positioning tape, stick one side of the tape along the score line you have drawn and use the scale on the score tape to determine the spacing of the score line. 3. Use a reciprocating or hook knife to gently pull the tape from one point back to the other along the side of the tear tape. Repeat this process until scribing is complete. Remember not to use force so as not to interfere with the scribing. Effect. 4. After completing the labeling, the labeling tape can be removed. The recommended time for sticking the labeling tape on the part should not exceed 30 days, otherwise environmental factors may cause adhesive residue when peeled off. Package Contents: 1* DSPIAE CG Series carving guide tape Notes: 1. Due to different measurement methods, the measurement allows an error of about 2-3 cm. This situation is not a quality problem. (1 inch = 2.54 cm) 2. Due to different lighting and screens, the color of the product may vary from the original color. Please prevail in kind.